Operating Instructions Network Audio Player N-70A/N-50A USB Audio Driver software (for Mac)
About these Operating Instructions When a USB cable is used to connect the unit’s USB DAC port to a computer, audio files located on the computer can be played. If this function is used to playback PCMs, there is no need to install a driver software on your computer. However, if you wish to use this function for DoP playback of DSD audio sources, you will need to install a special driver software on your computer.
Use a proper USB cable to connect a computer to a device equipped with USB DAC connector, then turn on the power. 6 Double-click on “Pioneer N-70A N-50A USB Audio”. Pioneer N-70A N-50A USB Audio For more information regarding connections, check the Operating Instructions for this device. Pioneer N-70A N-50A USB Audio Pioneer N-70A N-50A USB Audio USB A–type AL OUT 2 COAXIAL OPTICAL DC OUTPUT CONTROL For OUT WIRELESS LAN 5V AC IN DIGITAL IN The installer will start.
8 Select [Install for all users of this computer], then click on [Continue]. 10 Click on [Continue Installation]. Pioneer N-70A N-50A USB Audio The following screen will appear; wait until the step 11 instructions appear. Pioneer N-70A N-50A USB Audio Pioneer N-70A N-50A USB Audio “Installation Type” screen will appears. 9 Click on [Install]. Pioneer N-70A N-50A USB Audio 11 Click on [Restart]. Pioneer N-70A N-50A USB Audio Procedure continues. The driver installation is completed.
To uninstall the driver If you wish to uninstall (delete) the driver at any time after installing it, perform the following operation on your computer. 1 Double-click on “Pioneer N-70A N-50A USB Audio Uninstall”. The uninstaller dialog will appear. Note • The “Pioneer N-70A N-50A USB Audio Uninstall” file will appear after double clicking on “Pioneer N70A N50A.dmg”. (See Page 3) 2 Click [OK] to execute the uninstall process.
Troubleshooting 2. To disable the operating system’s sound scheme Under default OS settings, computer events may be accompanied by audio signals and beeps that are audible through the speakers attached to the device. In the event you do not wish to hear such non-music signals, follow the instructions listed below: 1. No sound Do not boot your computer’s music player program if the power is turned off to the device with the USB DAC port, or if the USB DAC port has not been selected as the input source.
3. To set the sampling frequency for audio data output from your computer By synchronizing the sampling frequency of playback files with the transmission sampling rate, sound can be transmitted without the need for frequency conversion. 2 Select [Pioneer N-70A N-50A USB Audio]. 3 Select the bit rate and sampling frequency for the desired audio file. Pioneer N-70A N-50A USB Audio 1 Click on [Finder] [Applications] [Utilities] [Audio MIDI Setup].
© 2014 PIONEER HOME ELECTRONICS CORPORATION. All rights reserved. PIONEER HOME ELECTRONICS CORPORATION 1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, Japan http://pioneer.jp PIONEER ELECTRONICS (USA) INC. P.O. BOX 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 http://www.pioneerelectronics.com/PUSA PIONEER ELECTRONICS OF CANADA, INC. 340 Ferrier Street, Unit 2, Markham, Ontario L3R 2Z5, Canada TEL: 1-877-283-5901, 905-479-4411 http://www.pioneerelectronics.
