Owner's Manual

13
En
Installation Procedure
3
Hang the hooks at the top of the display
sidefittingstothewallsidefittings(two
locations).
Attach the Pioneer display and television so that it aligns
with the guide labels. Check that the top hooks are
firmly hung and that the Pioneer display and television is
attached in its correct position and is level.
Hang the hooks at the top of the display side
fittings to the wall side fittings, pass a wire in
each spring hook, and attach it to the eye plate
(or eye bolt) attached to the wall.
Attach the wire after
temporarily attaching it to
the rear case with tape, etc.
Fix the wire to the eye
plate (or eye bolt).
Spring hook
Caution
Inthecaseofa60-inchdisplay,always
havethreeormorepersonsonhandwhen
installingthedisplay.Inthecaseofa50-inch
display,havetwoormorepersonsonhand.
Ìi
• Ifspeakersareattached,donotholdthespeakers
whenperformingthisattachment.
• Makesurethatthewiring,etc.,doesnotgetcaughtin
thettingsorthePioneerdisplayandtelevision.
• DonotforcefullypulldownthebottomofthePioneer
displayandtelevisionwhenthedisplaysidettings
hangfromthewallsidettingsbecausethismay
causethetoppartofthePioneerdisplayandtelevision
totouchthewall,resultinginscratchesordamage.
4
Adjust the Pioneer display and television
position.
The position of the Pioneer display and television can be
fine-adjustedhorizontallyandvertically.
Pioneer display and television
Wall mount unit
5
Fixthefittingswiththefall-prevention
screws(twolocations).
Tightenthetwofall-preventionscrewsofthedisplayside
fittings all the way.
Fall-prevention screws
Pioneer display and television
After fixing the fittings, remove the guide labels and the
fall prevention caution tag.
Caution
Besuretotightenthefall-preventionscrews
tosecurelyxthedisplaysidettingsand
thewallsidettings.
Ìi
Whenremovingthefall-preventioncautiontag,becareful
nottocutyourngers.