Owner's Manual

12
En
Installation Procedure
2
Temporarily attach the screw used for positioning about
192mm(inthecaseoftheKRP-WM01),or94mm(in
thecaseoftheKRP-WM02)abovethescreencenter
location.
192mm*
94 mm**
Screencenter
* : KRP-WM01
**: KRP-WM02
Temporarily attach
the screw.
3
Hang the wall side fittings on the screw referred to in
step
2
.
Hang the wall side fittings on the screw.
4
 Measurethedistancefromtheceilingtothewallside
fittings (A
1
, A
2
), and the distance from the floor to the
fitting(B
1
,B
2
), and after adjusting the wall side fittings
so that is level, fasten it to the wall with screws or bolts
fitted with supplied washers.
Ceiling
Floor
B1 B2
A1 A2
A1 = A2
or
B1 = B2
Screen center
5
Attach the guide labels to the wall and the Pioneer
display and television.
•Theguidelabelsareprovisionallabelsusedtoindicate
the wall attachment locations.
•Firstattachtheguidelabelstoaninconspicuous
location on the wall and check that they do not
damage the wall paper.
•Attachingtheguidelabelstothesurfaceofthe
Pioneer display and television may cause adhesive to
remain stuck to the surface, so attach the guide labels
on the rear side of the display as shown in the figure.
150 mm
Attach the guide
labels to the Pioneer
display and television.
Attach the guide
labels to the wall.