Owner's Manual

Install Your Flat Panel Display

Follow the steps below to secure your flat panel display.

1 ) Mark locations for metal fittings and screws on the back edge of the table using the panel stand to determine

placement.

2 ) Drill holes in the table or platform edge at the marked locations.

3 ) Lift panel into place with the assistance with at least one other person.

4 ) Use wood screws (not included) to secure the metal fittings to the table.

(KRP-600M)

20 mm

(13/16 inch)

min.

8 mm to 15 mm

(3/8 inch to 5/8 inch)

4 mm

(5/32 inch)

Falling prevention

metal fitting

(supplied with the

optional stand)

Wood screw

(commercially

available,

4 mm x 20 mm

(5/32 inch ×

13/16 inch)

min.)

Chapter_02.fm Page 18 Thursday, June 19, 2008 2:54 PM