Operation Manual

Basic operation
Resetting the microprocessor
- 13 -
C:\Program Files
(x86)\Adobe\AdobeFrameMaker12\Structure\xml\Pioneer\1.0\020Chapter.fm
DMH-160BT
KB010_MLUC(A6_Vertical)
English
CAUTION
• Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
• T
he microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other pointed tools.
Settings and recorded contents are reset to the factory settings.
Pioneer MNR.book Page 12 Tuesday, October 6, 2020 5:25 PM
Preparing the remote control
1770NEX
Remove the insulation sheet before use.
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (-) poles orientated properly.
WARNING
Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine,
fire or the like.