Operation Manual
- 114 -
C
:
\P
rogram
Fil
es
(x86)\Adobe\AdobeFrameMaker12\Structure\xml\Pioneer\1.0\020Chapter.fm
DMH-WT8600NEX/DMH-WT7600NEX/DMH-WC6600NEX/DMH-
W4660NEX/DMH-W4600NEX
20M_DMH_UC_EN(A6_Vertical)
English
*1 [All] is not available when [Network Mode] is selected as the speaker mode.
*2 If you change the listening position setting, the set values for all speakers will change in
c
onjunction with this setting.
*3 To use this function, the vehicle’s acoustics must be measured in advance.
*4 This function is available only when the listening position setting is set to [Front Left] or [Front
R
ight].
*5 This function is not available when adjusting the High speaker in [Network Mode].
You can adjust the cutoff frequency value of each speaker.
The following speakers can be adjusted:
[S
tandard Mode]: Front, Rear, Subwoofer.
[Network Mode]: High, Mid, Subwoofer.
NOTE
[Subwoofer Settings] is available only when [Subwoofer] is [On].
1 Touch then swipe left on the screen.
2 Touch then .
3 Touch [Crossover] or [Subwoofer Settings].
4 Touch or to switch the speaker.
5 Drag the graph line to set the cutoff position.
6 Drag the lowest point of the graph to set the cutoff slope.
The following items can also be set.
Switches the subwoofer phase between normal and reverse position.
You can also adjust the [High] and [Mid] phase in [Network Mode].
[LPF]/[HPF]
Switches the [LPF]/[HPF] setting to [On] or [Off]. When it is turned off, the high-
pass filt
er or low-pass filter of each speaker can also be turned on by touching the
graph lines.
Video settings
The menu items vary according to the source.
[Load Settings]
[Initial Settings] [Sound
S
etting]
Load the sound settings.
NOTE
[Sound Setting] is available only when you have already saved the
sound settings (page 113).
Adjusting the cutoff frequency value
TIP
Menu Item Description
3LRQHHU015ERRN3DJH:HGQHVGD\-DQXDU\$0