User's Manual

26
Troubleshooting
Common
Symptom Cause Action
The power will not
turn on. The unit will
not operate.
Leads and connectors
are incorrectly
connected.
Conrm once
more that all
connections
are correct.
The fuse is blown.
Rectify the
cause and
then replace
the fuse. Be
sure to install
a fuse with the
same rating.
Noise and/or other
factors are causing the
built-in microprocessor
to operate incorrectly.
Press RESET.
Operation with the
remote control is not
possible.
The unit does not
operate correctly even
when the appropriate
remote control buttons
are pressed.
Battery power is low.
Load a new
battery.
There is no sound.
The volume level will
not rise.
Cables are not
connected correctly.
Connect the
cables
correctly.
The aspect ratio is
incorrect and the
image is stretched.
The aspect ratio setting
is incorrect for the
display.
Select the
appropriate
setting for
your display.
There is no
image displayed.
The parking brake
cable is not connected.
Connect the
parking
brake cable,
and apply the
parking
brake.
The image displayed
stops (pauses) and
the unit cannot be
operated.
The data could no
longer be read during
playback.
Stop playback
once, and
start playback
again.
There is no sound.
The volume level is
low.
The volume level is
low.
Adjust the
volume level.
The sound and video
skip.
The unit is not rmly
secured.
Firmly secure
the unit.
Sub-folders cannot be
played back.
Folder repeat play has
been selected.
Select the
repeat range
again.
The repeat
range changes
automatically.
Another folder was
selected during repeat
play.
Select the
repeat range
again.
Track search or fast
forward/reverse was
performed during le
repeat play.
Select the
repeat range
again.
The sound from
the Bluetooth audio
source is not played
back.
There is a call
in progress on a
Bluetooth connected
cellular phone.
The sound
will be
played
back when
the call is
terminated.
A Bluetooth
connected cellular
phone is currently
being operated.
Do not
operate
the cellular
phone at
this time.
A call was made
with a Bluetooth
connected cellular
phone and then
immediately
terminated.
As a result,
communication
between this unit and
the cellular phone
was not terminated
properly.
Reconnect
the
Bluetooth
connection
between
this unit and
the cellular
phone.
Error messages
When you contact your dealer or your nearest Pioneer Service
Center, be sure to note the error message.
Message Cause Action
Bad Disc
Disc is dirty.
Clean disc with soft
cloth.
Disc is upside down.
Insert disc with
label side up.
Unsupported
Video
The video resolution
exceeds 720X576.
Change to a
supported le.
Unsupported
format
File format is not
compatible with this unit.
Change to a
supported le.
File Error
File format is not
compatible with this unit.
Change to a
supported le.
Disc region
incorrect
Disc format is not
compatible with this unit.
Change another
disc.
Amplier Error!
Unit fails to operate or
speaker connection is
incorrect; protective
circuit is activated.
Check the speaker
connection. If the
message fails to
disappear even
after the engine
is switched off/
on, contact your
dealer or an
authorized Pioneer
Service Station for
assistance.
Format read
Disc or storage device is
being read.
Please wait, it
may take several
minutes for some
disc or storage
device.
Check USB
The USB over rated
current.
Check the USB
device or change
the USB device.
Appendix