User's Manual

4
01
Section
En
Precautions
To avoid battery exhaustion
Keep the vehicle engine running when
using this unit to avoid draining the battery
power.
• When no power is supplied to this unit,
such as when the vehicle battery is
being replaced, the microcomputer of
this unit returns to its initial condition. We
recommend that you transcribe the audio
adjustment data.
WARNING
Do not use with vehicles that do not feature
an ACC position.
CAUTION: USE OF CONTROLS OR
ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
CAUTION: THE USE OF OPTICAL
INSTRUMENTS WITH THIS PRODUCT
WILL INCREASE EYE HAZARD.
CAUTION
This product is a class 1 laser product
classified under the Safety of laser
products, IEC 60825-1:2007.
FCC STATEMENT
1. This device complies with Part 15 of the
FCC Rules.Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interferencethat may
causeundesired operation.
2. Changes or modifications not expressly
approved by the party responsible
forcompliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for aClass
B digital device, pursuant to Part 15 of
the FCC Rules. These limits aredesigned
to provide reasonable protection against
harmful interference in aresidential
installation.
This equipment generates uses and can
radiate radio frequency energy and,if not
installed and used in accordance with the
instructions, may causeharmful interference
to radio communications. However, there
is noguarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or televisionreception, which can
bedetermined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or more
ofthe following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet
on a circuit different from that towhich
the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be
installed and operated with minimum
distance 20cm between the radiator & your
body