User's Manual

# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 33.
Disconnecting a Bluetooth device
This function can be operated only when the
Bluetooth wireless connection is being estab-
lished.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 29.
2 Use MULTI-CONTROL to select
DisconnectDevice.
3 Push MULTI-CONTROL up or down to
select the special device.
# If only one device was found, this step cannot
be performed.
4 Press MULTI-CONTROL to disconnect
the Bluetooth wireless connection.
While disconnecting, Disconnecting flashes.
If the Bluetooth wireless connection is termi-
nated, Disconnected is displayed.
# If multiple Bluetooth devices have been con-
nected and you wish to disconnect them, press
MULTI-CONTROL and then select the device. In
this case, repeat operation from step 3.
Deleting a paired phone
1 Display the connection menu.
Refer to Introduction to connection operations
on page 29.
2 Use MULTI-CONTROL to select
Delete device.
3 Push MULTI-CONTROL up or down to
select the special device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left to display the BD
address.
# If device name cannot be obtained, BD ad-
dress is displayed.
4 When the device name is being dis-
played, push MULTI-CONTROL right to dis-
play Delete YES.
Deleting device is now on standby.
# If you do not want to delete the device, push
MULTI-CONTROL lef t.
5 Press MULTI-CONTROL to delete the de-
vice.
After the device is deleted, Deleted is dis-
played.
Selecting a service
You can choose a Bluetooth service from
phone service, AVRCP service or A2DP ser-
vice.
1 Display the connection menu.
Refer to Introduction to connection operations
on page 29.
2 Use MULTI-CONTROL to select Service.
3 Push MULTI-CONTROL up or down to
select the special device.
# If only one device was found, this step cannot
be performed.
# Push MULTI-CONTROL left or right to switch
the BD address and device name.
# If device name cannot be obtained, BD ad-
dress is displayed.
4 Press MULTI-CONTROL to display the
service select screen.
5 Push MULTI-CONTROL up or down to
select the service.
Phone—AVRCP—A2DP
# “*” is displayed on the connected service.
# Profile that is not compatible with the con-
nected device cannot be selected.
6 Press MULTI-CONTROL to start or stop
the selected service.
Using Bluetooth wireless technology
En
31
English
Section
08