Operation Manual

Getting started04
54
En
Basic operation
Procedures for listening to audio from a radio
or connected other component.
1 Turn on the power of the playback
component.
2Press
 SYSTEM to turn on the power of
this system.
3 Select the source you want to playback.
Use the MULTI CONTROL (or INPUT
SELECTOR) buttons.
• Select the type of audio input signal if
required (see below).
4 Start playback of the component you
selected in step 1.
5 Select the listening mode.
Use the listening mode buttons.
6Press MASTER VOLUME +/– to adjust the
volume.
Choosing the input signal
On this system, it is possible to switch the
input signals for the different inputs as
described below.
1
1 Press on the remote control.
2 Press
SIGNAL SEL to select the input
signal corresponding to the source
component.
When DIGITAL (C1/O1/O2) or HDMI (H) is
selected and the selected audio input is not
provided, A (analog) is automatically selected.
Each press cycles through the following:
• A – Selects the analog inputs.
• DIGITAL – Selects the digital input. The
coaxial 1 input is selected for C1, and the
optical 1 or 2 audio input is selected for
O1 or O2.
• HDMI – Selects an HDMI signal. H can be
selected for BD/DVD, VIDEO or DVR/VCR
input. For other inputs, HDMI cannot be
selected.
2
When set to DIGITAL or HDMI, 2 lights when
a Dolby Digital signal is input, and DTS lights
when a DTS signal is input.
When the HDMI is selected, the A and
DIGITAL indicators are off (see page 44).
SYSTEM
SYSTEM
TV CONTROL
CH
VOL
DIMMER SIGNAL SEL
BD MENU
INPUT
INPUT SELECT SOURCE
TOP
MENU
HOME
MENU
RETURN
ST/MONO
DTV/TV
BASS TRE
SETUP
PTY SEARCH
AUDIO
PARAMETER
iPod CTRL
MASTER
VOLUME
TOOLS
MENU
ENTER
MUTE
TUNER EDIT
Note
1 • This system can only play back Dolby Digital, PCM (32 kHz to 96 kHz) and DTS (including DTS 96 kHz / 24 bit) digital
signal formats. The compatible signals via the HDMI terminals are: Dolby Digital, DTS, SACD (DSD 2 ch), PCM (32
kHz to 192 kHz sampling frequencies), Dolby TrueHD, Dolby Digital Plus, DTS-EXPRESS, DTS-HD Master Audio and
DVD Audio (including 192 kHz). With other digital signal formats, set to A (analog).
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise,
make the proper digital connections (page 33) and set the signal input to C1/O1/O2 (DIGITAL).
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your
DVD player.
2 When the HDMI option in Setting the Audio options on page 69 is set to THRU, the sound will be heard through your
TV, not from this system.
SYSTEM
TV CONTROL
CH
VOL
DIMMER SIGNAL SEL
BD MENU
INPUT
HTP-710_VYXCN_En.book 54 ページ ２０１０年８月２３日 月曜日 午後６時４７分