Installation guide

Installation using the screw holes on the side of the navigation unit

1. Fastening the navigation unit to the factory radio-mounting bracket.

Position the navigation unit so that its screw holes are aligned with the screw holes of the

bracket, and tighten the screws at 3 or 4 locations on each side. Use either the binding

screws (5 × 6 mm) or flush surface screws (5 × 6 mm), depending on the shape of the

bracket’s screw holes.

Note:

In some types of automobiles, discrepancy may occur between the navigation unit and the dashboard. If

this happens, use the supplied frame to fill the gap.

ENG/MASTER 96

English

Español

Deutsch

Français

Italiano

Nederlands

<CRD4324A/U> 23

Factory radio mounting bracket

Binding screw or

flush surface screw

Be sure to use the

screws supplied

with this navigation

system.

Dashboard or console

If the pawl gets in the

way, bend it down

02_CRD4324-A_inst_001_029_UK 08.1.28 2:56 PM Page 23

<CRD4324-A> 23