User Manual

Black plate (7,1)
The point of connector
attachment/detachment
! Push in the connector until a clicking
sound, and connect it certainly.
! When you remove the connector, hold the
connector portion and pull it. When the
cord is pulled, the cord may be pulled out
from the connector.
About bridged mode
! Do not install or use this amplifier by wiring
speakers rated at 4 W (or lower) in parallel to
achieve a 2 W (or lower) bridged mode (Dia-
gram B).
Amplifier damage, smoke, and overheating
could result from improper bridging. The am-
plifier surface could also become hot to the
touch and minor burns could result.
To properly install or use a bridged mode and
achieve a 4 W load, wire two 8W speakers in
parallel with Left + and Right * (Diagram A)
or use a single 4W speaker.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
! For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W,or4W to 8 W for two-channel and other
bridge connections.
Subwoofer
Speaker channel Power
Four-channel output
Nominal input:
Min. 45 W
Two-channel output
Nominal input:
Min. 90 W
Three-channel Front
speaker out
Nominal input:
Min. 45 W
Three-channel Rear
speaker out
Nominal input:
Min. 90 W
Other than subwoofer
Speaker channel Power
Four-channel output
Max. input:
Min. 100 W
Two-channel output
Max. input:
Min. 200 W
Three-channel Front
speaker out
Max. input:
Min. 100 W
Three-channel Rear
speaker out
Max. input:
Min. 200 W
Connecting the speakers
The speaker output mode can be four-channel,
three-channel (stereo and mono) or two-chan-
nel (stereo or mono). Connect the speaker
leads based on the mode and the figures
shown below.
En
7
English
Section
03
Connecting the units


5707000009391V<7>