Owner's Manual
Table Of Contents
(Connecting
the
units
)
Connecting
the
speaker
output
terminals
1
Use
wire cutters or a utility knife to
strip the end
of
the speaker wires to ex-
pose
about 10 mm (3/8 in.)
of
wire and
then twist the wire.
Twist
r-r
10
mm
(3/8
inch)
2 Attach
lugs
to wire ends.
Use
pliers, etc.,
to
crimp
lugs
to
wires.
/D
CD
Lug (sold separately)
W Speaker wire
3 Connect the speaker wires
to
the
speaker output terminals.
Fix
the
speaker
wires
securely
with
the
term-
inal
screws.
~~
CD
Terminal screws
W Speaker wires
G)
Speaker
output
terminals[!]
En
(
Installation
)
Before installing the amplifier
AwARNING
·
•
To
ensure proper installation, use the supplied
parts in the
manner
specified. If any parts
other
than those supplied are used, they may
damage internal parts of
the
amplifier,
or
be-
come
loose causing the
amplifier
to
shut
down.
• Do not install in:
- Places where it could injure the driver
or
passengers if the vehicle stops suddenly.
- Places where it may interfere
with
the dri-
ver,
such as on the
floor
in
front
of the dri-
ver's seat.
• Install tapping screws in such a way
that
the
screw
tip
does not
touch
any wire. This
is
im-
portant to prevent wires
from
being
cut
by
vi-
bration of the
car,
which
can result in fire.
• Make sure
that
wires do not get
caught
in
the
sliding
mechanism
of the seats
or
touch
the
legs of a person in the vehicle as short-circuit
may result.
• When drilling to install the amplifier, always
confirm
no parts are behind the panel and
protect all cables and
important
equipment
(e.g. fuel/brake I i nes, wiring)
from
damage.
A
cAUTION
•
To
ensure proper heat dissipation of the
amp
I
i-
fier, ensure the following
during
installation:
-
Allow
adequate space above the
amplifier
for
proper venti I at ion.
- Do not cover
the
amplifier
with a
floor
mat
or
carpet.
• Protection
function
may activate to protect
the
amplifier
against overheating due to installa-
tion in locations where
sufficient
heat
cannot
be
dissipated,
continuous
use
under
high-vo-
lume
conditions, etc.
In
such cases, the am-
pi
ifier reduces the power
output
or
shuts
down until it has cooled to a certain desig-
nated temperature.
• Place all cables away
from
hot places, such
as near the heater outlet.
• The optimal installation location differs de-
pending on the
car
model. Secure the ampli-
fier at a sufficiently rigid location.