Owner's Manual

(Connecting the units )
Connecting
the power
terminal
The use of a special red battery and ground
wire RD-223 (sold separately) is recom-
mended. Connect the battery wire directly to
the
car battery positive terminal ~and the
ground wire to the car body.
A wARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating,
malfunction and injury, including
minor burns.
1 Route battery wire from engine com-
partment to the vehicle interior.
• When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care
not to short-circuit the
wire damaging it by the cut edges or burrs
of
the hole.
After completing all other am pi ifier con nec-
tions, finally
connect the battery wire terminal
of the amplifier to the positive~ battery term-
inal.
CD Positive® terminal
W Engine compartment
® Vehicle interior
@ Fuse (30 A) x 2
® Insert the 0-ring rubber grommet into the
vehicle body.
® Drill a 14 mm (1/2 in.) hole into the vehicle
body.
En
2 Twist the battery wire, ground wire
and
system remote control wire.
Twist
------.w~
3 Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
~~~
"'Y.~~~~
~, \\
1l ® "''
CD Lug (sold separately)
W Battery wire
® Ground wire
4 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
4
CD System remote control terminal
W Ground terminal
® Power terminal
@ Terminal screws
® Battery wire
® Ground wire
(JJ System remote control wire C!J