Owner's Manual

( Connecting
the
units
CD
Terminal screws
0
Speaker wires
®
Speaker
output
terminals[!]
)
En
(
Installation
)
Before
installing
the amplifier
A
wARNING
•
To
ensure proper
installation,
use the
supplied
parts in the
manner
specified.
If
any parts
other than those
supplied
are used, they may
damage internal parts of the amplifier,
or
be-
come
loose
causing the amplifier to
shut
down.
•
Do
not
install
in:
-
Places
where it
could
injure the driver
or
passengers if the vehicle
stops
suddenly.
-
Places
where it may interfere with the dri-
ver,
such as on the
floor
in front of the dri-
ver's seat.
• Install
tapping screws in such a way
that
the
screw
tip
does not touch any wire. This
is
im-
portant to prevent wires from being
cut
by
vi-
bration of the
car,
which
can
result
in fire.
•
Make sure
that
wires do not get
caught
in the
sliding
mechanism of the
seats
or
touch
the
legs
of a person in the
vehicle
as
short-circuit
may
result.
•
When
drilling
to
install
the amplifier,
always
confirm no parts are behind the
panel and
protect
all cables
and important equipment
(e.g. fuel/brake lines, wiring) from damage.
A
cAUTION
•
To
ensure proper heat dissipation of the
ampli-
fier, ensure the
following during
installation:
-
Allow
adequate space above the amplifier
for proper ventilation.
- Do not cover the
amp
I
ifier with a
floor
mat
or
carpet.
•
Protection function may activate to protect the
amplifier
against overheating due to
installa-
tion in locations where sufficient heat cannot
be
dissipated,
continuous
use under high-vo-
lume
conditions, etc.
In
such cases, the am-
plifier
reduces the power
output
or shuts
down until
it has
cooled
to a certain desig-
nated temperature.
• Place all cables away from hot
places,
such
as
near the heater
outlet.