SDS

Page 2 of 6
Fiberglass Reinforced Plastic (FRP)
Skin Contact: Wash affected areas with soap and water. Get medical attention if rash or irritation
persists or dermatitis occurs.
Ingestion: Rinse mouth with water. Get medical attention if irritation persists.
Recommendations for Immediate Medical Care/Special Treatment: None known.
SECTION V – FIREFIGHTING MEASURES
Extinguishing media:
Water Fog, Carbon Dioxide, Dry Chemical, Chemical
Foam.
Special Hazards:
May form combustible dust concentrations in air if
small particles are generated during further processing,
han
dling or by other means.
Panels exposed to fire may liberate oxides of nitrogen
and carbon and hydrocarbons.
Recommendations on Protective Equipment:
Firefighters should use appropriate personal protective
equipment including self-contained breathing apparatus.
SECTION VI – ACCIDENTAL RELEASE MEASURES
Personal Precautions/Emergency Procedures:
No special precautions required.
Environmental Precautions:
No special precautions required.
Clean-up Procedures:
No special procedures required.
SECTION VII – HANDLING AND STORAGE
Precautions to be taken in handling and
storing:
Store flat if possible. Avoid excessive heat or humidity.
Incompatibility (Materials to Avoid):
None Known
SECTION VIII – EXPOSURE CONTROL /PERSONAL PROTECTION
OSHA Permissible Exposure Limits:
Particulate
TWA: 15.0 mg/m3 (total dust)
TWA: 5.0 mg/m3 (respirable fraction)
Ventilation controls:
When dust is created use local ventilation where required to
maintain airborne levels below OSHA PELs
Hand protection:
Gloves may be worn to prevent contact with rough laminate
edges.