Instructions / Assembly

5
Installation Instructions
Cut to size. If the bolts is
too long, it will be
troublesome to move it in
the future.
Concrete
Anchor Bolt
[Unit: in. (mm)]
Concrete Base or Similar
Min. 4 in. (10cm)
Set Screw
(at least 4)
About 16 in. (40cm)
About 4 in. (10cm)
Fig.1
Fig.2
Fig.3
(1) Use the washers to fasten the machine at the foundation bolts.
(2) When fastening the outdoor unit with foundation bolts, the fastening hole positions are shown in Fig.1.
(3) Fasten the outdoor unit as shown in Fig.2.
(4) Be sure to properly fasten the outdoor unit tightly and fully horizontally, to prevent noise when the machine is
oblique or inclined by strong breezes or earthquake.
(5) Do not drain off water to public places, to avoid skidding.
(6) A strong base (made of concrete, etc.) should be made beforehand. The appliance should be placed no less than
10 cm high, to avoid getting wet or corroded. Otherwise, it can cause damage to the appliance or reduce its
lifetime. (Fig.3)
Drainage Elbow and Drain Hose Installation
Outdoor Unit Installation
Install Drainage Elbow and Drain Hose
·
·
·
The condensate water may drain from the outdoor unit
when the unit operates in heating mode. In order to avoid
disturbing neighbors and to protect the environment, it is
necessary to install a drainage elbow and a drain hose to
properly drain out and route the condensate water away.
Handle the drainage work before the indoor unit and
outdoor unit are connected. Otherwise, it will be difficult to
install the drainage elbow after the machine is mounted
Connect the drain hose (field-supplied, with inside
diameter: 15mm) as shown in the figure for drainage.
Drain Hose
Drainage Elbow
NOTE:
Do not use the drainage elbow in cold regions.
Drainage may freeze and stop the fan from running.
.
Model A B C D E F
d
24K
33-7/8
(860)
12-
3/16
(310)
21-11/32
(542)
13-7/16
(341)
14-1/2
(368)
6-5/8
(168)
7/16*21/32
(11*17)
36K/48K
/60K
37-
3/8
(950)
13-3/8
(340)
22-7/8
(580)
14-15/16
(380)
16-1/4
(414)
7-
1/4
(185)
5/8
(15)