Operation Manual

Additional information
17
134
En
Network (DVR-660H-K only)
If the unit does not operate normally due to external effects such as static electricity, disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
If the picture freezes and the front panel and remote control
buttons stop working
•Press  (Stop) then try restarting
playback.
•Press the front panel  STANDBY/ON
button to switch the power off, then
switch back on and restart playback. If
the power fails to switch off, press and
hold  STANDBY/ON for five seconds
until the power switches off.
Problem Remedy
Cannot connect to
network
• Turn this unit’s power off and on again.
• Check that the LAN cable is properly connected.
• Check that the router’s power is turned on.
The Connect PC
function does not work
properly with an
Ethernet connection
• Check that the IP address is properly set.
• Either turn the router’s DHCP server function on or change the
Network settings according to the environment (page 121).
• On the PC, click ‘Start’, ‘Network’, and then ‘Network and Sharing
Center’ on the command bar. When the ‘Network and Sharing Center’
window appears, ensure that ‘Network discovery’ under the ‘Sharing
and Discovery
’ section is enabled.
• From ‘Network’ on the PC, right-click the ‘Pioneer.HDD/DVD-
Recorder’ icon and select ‘Uninstall’. A comfirmation message may
appear. In this case, press ‘Continue’. Wait at least 30 seconds, then
reconnect the PC using the procedure described at Ethernet
connection on page 102.
• Normal operation may be unavailable if the connected equipment
has Internet security software installed in it.
DVD
OPEN/CLOSE
STANDBY/ON
USB
DV IN
CH
INPUT
SELECT
STOP REC
HDD
HDD/DVD
STANDBY/ON
DVR660HK_KC_EN.book 134 ページ ２００８年２月７日 木曜日 午後２時３４分