Operation Manual

The Initial Setup menu
16
114
En
VCR Plus+ CH
Setting
Next Screen Guide channels are used by the VCR Plus+ system so that
the channel number specified in the VCR Plus+
programming numbers can be guaranteed to correspond to
the correct station. Look in your TV guide to see which
channel numbers should be assigned to which guide
channels.
• Use the / buttons to change the guide channel for
setting.
• Use the / buttons to change the channel number.
• Use the PREV / NEXT
 button to display the
previous/next 10 guide channels.
• To return to the Initial Setup menu, press ENTER.
Video Out
Component
Video Out
Interlace • Select if your monitor/TV is not compatible with progressive-
scan video.
Progressive Select if your monitor/TV is progressive-scan compatible.
Check the operating instructions that came with your
monitor/TV if you’re not sure.
• If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any
picture at all. In this case, press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to
switch to Interlace (this also switches Screen Resolution on page 119 to the default setting).
• When the HDMI signal is output, no video is output from the COMPONENT VIDEO OUT.
Audio In
External Audio Stereo • Select if the audio from the currently selected external input
is standard stereo.
Dual Mono Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder
whether the audio is stereo or dual mono. This has priority over the setting you make here.
Dual Mono
Recording
L • Select to record the left channel of an external dual mono
source when recording to DVD in Video mode, to HDD with
HDD Recording Format set to Video Mode On, or in LPCM
mode.
R As above, but for right channel recording.
When recording dual mono audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording
Format set to Video Mode Off (except in LPCM mode), both audio channels are recorded and you can switch to the
one you want on playback.
Setting Options Explanation
DVR660HK_KC_EN.book 114 ページ ２００８年２月７日 木曜日 午後２時３４分