Specifications

In the Advanced Settings tab you will see the Transfer Mode drop-down box where the current transfer mode is displayed. To

change the transfer mode and enable DMA you should open the drop-down box and choose DMA if available option:

After that click OK to accept the changes you have made. The same can be done for the Secondary IDE Channel. After you

enabled DMA modes for the IDE channels you can close the device manager window. Sometimes the reboot might be needed to apply

all the changes.

Note: not all the controllers allow the user to change the transfer mode. If you install the third party driver for

your computer IDE controller see the instructions that go along with the driver software. Usually when the

special driver for the controller is installed the DMA mode is enabled automatically by the driver software.

AVS4YOU Programs Help - Appendix

Page 49 of 53