Owner's Manual

English
- 101 -
Sound from the iPod cannot be heard.
→ The audio output direction may switch
automatically when the Bluetooth and
USB connections are used at the same
time.
– Use the iPod to change the audio
output
di
rection.
No back camera image when the vehicle
is in reverse.
→ The back camera input setting on the
receiver is set to Off.
–Change the back camera setting to On
in
the settings menu. (Refer to the
System Settings section of this manual
to adjust.)
→ T
he camera input may be loose or not
co
nnected.
–Check the connection and make sure
th
e male end of the camera is
connected to the brown input on the
back of the receiver. (Refer to the
installation manual.)
→ T
he reverse lead on the receiver may
n
ot be connected to the proper wire at
the reverse lamp.
–Check the connection and make sure
th
a
t the violet/white lead of the
receiver is connected to the lead
whose voltage changes when the shift
lever is put in reverse. (Refer to the
installation manual.)
Black screen displayed when the vehicle
is in reverse, with no camera installed.
→ Back camera input is set to On.
–Turn the setting to Off in the settings
menu.
(Refer to the System Settings
section of this manual to adjust.)
Back image displayed when vehicle is not
in reverse.
→ The camera polarity is not set properly
in the Camera settings menu.
–Review System Settings section of this
ma
nual for steps to switch the camera
polarity. Park in a safe place, then
while keeping your foot firmly on the
brake, put the vehicle in reverse,
access the System Settings menu, and
change the camera polarity setting.
Put vehicle back in park. (Refer to the
System Settings section of this manual
to adjust.)
Dialing is impossible because the touch
panel keys for dialing are inactive.
→ Your phone is out of range for service.
–Retry after re-entering the range for
ser
vice.
→ The connection between the cellular
phone and t
his product cannot be
established.
–Perform the connection process.
→ O
f the two cellular phones connected
t
o this product at the same time, if the
first phone is dialing, ringing or a call is
in progress, dialing cannot be
performed on the second phone.
–When the operation on the first of the
tw
o c
ellular phones is completed, use
the switch devices key to switch to the
second phone and then dial.
A black screen is displayed.
→ While operating an application, the
application was ended on the
smartphone side.
–Touch (press) to display the top
menu screen.
→ T
he smartphone OS may be awaiting
screen
operation.
–Stop the vehicle in a safe place and
check t
he screen on the smartphone.
Problems with the phone screen
Problems with Application
screen
I ___ I
--- 1 ___ 1
..
..
-