User Manual

21
En
Changing the settings
Changing the settings
Setting preferences
*: Default setting
Setting items Setting value Descriptions
Setting items Level indicator Setting value Level indicator
MASTER OUT ATT.
[CH1] top indicator flashes
0 dB* [CH2] 0 dB or less turns on
Set the attenuation level of the sound from [MASTER1]
output terminals or [MASTER2] output terminals.
–6dB
[CH2] -6 dB or less turns on
–12dB
[CH2] -12 dB or less turns on
MIDI CH
[CH1] 2nd from top indicator
flashes
1* ~ 16
MIDI channels 01 to 09 are shown by the
number of [CH2] indicators turned on.
MIDI channels 10 to 16 are shown by the
top [MASTER] and up to 6 [CH2] indicators
turned on.
Set the MIDI channel.
MIDI BUTTON TYPE
[CH1] 3rd from top indicator
flashes
TOGGLE* [CH2] orange indicators turn on
Set how to transmit the MIDI signal.
TRIGGER
[CH2] green indicators turn on
PC UTILITY
[CH1] 4th from top indicator
flashes
ON
[CH2] orange indicators turn on
Set whether to automatically launch the setting utility
software of the computer when connecting the unit to the
computer using a USB cable.
OFF* [CH2] green indicators turn on
AUTO STANDBY
[CH1] 5th from top indicator
flashes
ON* [CH2] orange indicators turn on
Turn the auto standby function on or off.
OFF
[CH2] green indicators turn on
FACTORY RESET
[CH1] bottom indicator
flashes
RESET
[CH2] orange indicators turn on
All settings are reset to their defaults.
CANCEL
[CH2] green indicators turn on
VERSION
[CLIP] indicator on
[MASTER] flashes
1.0 or more
1 digit: [CH1]
0.1 digit: [MASTER]
0.01 digit: [CH2]
It shows the firmware version.
Changing procedures
1 While pressing the [FILTER] button, press the 
switch.
The top [CH1] indicator flashes.
2 Press the [CUE] button for channel 1 to select the
setting item.
A different [CH1] indicator or [CLIP] indicator on [MASTER] flashes.*
3 Press the [CUE] button for channel 2 to select the
setting value.
For turning on the level indicators, the number of indicator or the color
changes.*
4 Press the [FILTER] button to set the setting value.
The level indicators fast flashes.
5 Press and hold the [FILTER] button for more than 1
second.
The changing procedure is completed.
* For flashing or lighting indicators, see “Setting preferences” above.
About the auto standby function
When [AUTO STANDBY] is set to [ON], the unit automatically enters
the standby mode if 10 hours elapses with all of the following conditions
met.
— That none of this unit’s buttons or controls are operated.
— That no audio signal is input to each channel of this unit.
! In the standby mode, the [STANDBY] indicator is lit.
! When the [FILTER] button is pressed, the standby mode is canceled.
! This unit is shipped with the auto standby function turned on. If you
do not want to use the auto standby function, set [AUTO STANDBY]
to [OFF].