User Manual

En
35
Changing the settings
dB
Frequency
[Talkover Level] setting of [MIC] input
Sets the talk over function’s sound attenuation level.
Setting values: –6 dB / –12 dB / –18 dB / –24 dB
About the driver software and
setting utility software
This unit functions as an audio device conforming to the ASIO
standards.
Using the settings utility software
This function can only be used by those using a Windows operating
system.
0 Launching the settings utility software
For Windows 10/8.1
Click [Pioneer] > [DDJ_WeGO4 ASIO Settings Utility] from [Apps
view].
For Windows 7
Click [All Programs] > [Pioneer] > [DDJ_WeGO4] > [DDJ_WeGO4
ASIO Settings Utility] from the [Start] menu of Windows.
0 Adjusting the buffer size
In the same way as the setting of [Buffer Size], decreasing the value of
the [Kernel Buffers] setting lowers the transfer delay (latency) of the
audio data, while increasing the value reduces the tendency for dropouts
(breaks in the sound) to occur in the audio data (the default setting of
[Buffer Size] is 512 samples/10 ms and the default setting of [Kernel
Buffers] is [3]).
! If the [Buffer Size] or [Kernel Buffers] number is made large, drops
in the data (breaks in the sound), etc., occur less easily, but the time
lag due to transmission delays in the audio data (latency) increases.
0 If breaks in the sound occur with the default
setting
1 Launch [DDJ_WeGO4 ASIO Settings Utility] and
change [Kernel Buffers] to [4].
2 Set to the minimum [Buffer Size], with which breaks
in the sound do not occur.
0 If no breaks in the sound occur with the default
setting
1 Launch [DDJ_WeGO4 ASIO Settings Utility] to set to
the minimum [Buffer Size], with which breaks in the
sound do not occur.
2 Change [Kernel Buffers] to [2], and check that no
breaks occur in the sound.
3 If no breaks occur in the sound, set to the minimum
[Buffer Size]. If breaks do occur in the sound, change
[Kernel Buffers] to [3].
Checking the version of the driver
software
For Windows 10/8.1
From [Apps view], click [Pioneer] > [DDJ_WeGO4 Version Display
Utility].
For Windows 7
Click [All Programs] > [Pioneer] > [DDJ_WeGO4] > [DDJ_WeGO4
Version Display Utility] from the Windows [Start] menu.
! You can check the firmware version of this unit on the screen.
! The firmware version is not displayed when this unit is not connected
to the computer or when this unit and computer are not properly
communicating.
Checking the latest information on the
driver software
For the latest information on the driver software for exclusive use with
this unit, see [DDJ-WeGO4] from the [DJ CONTROLLER] category of
[Software] of the Pioneer DJ site below.
http://www.pioneerdj.com/en/support/software/