User Manual

En
25
Using rekordbox
Monitoring sound with headphones
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc. Position
[HEADPHONES LEVEL] control Turned fully counterclockwise
2 Press the [HEADPHONES SELECT 1] button.
3 Turn the [HEADPHONES LEVEL] control.
Adjust the sound level output from the headphones to an appropriate
level.
Inputting the sound of the microphone
The sound of the microphone connected to the [MIC] input terminal can
be mixed.
1 Connect the microphone to the [MIC] input terminal.
2 Click the [MIXER/MIC] button in rekordbox dj to
display the mixer panel.
3 Click the [MIC ON] button in rekordbox dj.
4 Turn the [MIC LEVEL] control to adjust the audio level
of the microphone.
The EQ can be adjusted and effects can be applied by connecting with
rekordbox.
For the detailed operating procedures, see the Operating Instructions of
rekordbox.
Quitting the system
1 Quit rekordbox.
2 Press the [STANDBY/ON] button until the unit enters
standby.
rekordbox Advanced Operation
The descriptions from this point on are for functions that are specific
for when this unit and rekordbox dj are used in combination and are
not described in the rekordbox Operating Instructions.
Using hot cues
Playback can be started instantaneously from the position at which a
hot cue is set. In addition to hot cues, loops can be set and called out
instantaneously.
! Up to eight hot cue points can be set and saved per track, but only up
to four can be operated with the buttons of this unit.
0 Setting and calling out a hot cue
1 When the [HOT CUE] indicator is off, press the
[HOT CUE/SAMPLER] mode switching button.
The unit switches to the hot cue mode and the indicator lights.
2 Press a performance button to set a hot cue point
during playback or pause.
Hot cue points are assigned to the respective performance buttons as
shown below.
[1] Hot cue A
[2] Hot cue B
[3] Hot cue C
[4] Hot cue D
3 Press the performance button with the hot cue point
set.
Playback starts from the hot cue point.
! A set hot cue point can be cleared by pressing a performance button
while pressing the [SHIFT] button.