User Manual

En
30
CH1
(USB1/2)
CH2
(USB3/4)
CH3
(USB5/6)
CH4
(USB7/8)
CH5
(USB9/10)
— —
CH3 Control
Tone
PHONO
1
CH4 Control
Tone
PHONO
1
REC OUT
2
CH1 Control
Tone CD
1
CH2 Control
Tone CD
1
CH3 Control
Tone LINE
1
CH4 Control
Tone LINE
1
REC OUT (NO
MIC)
Post CH1
Fader
2
Post CH2
Fader
2
Post CH3
Fader
2
Post CH4
Fader
2
Cross
Fader A
2
Cross
Fader A
2
Cross
Fader A
2
Cross
Fader A
2
Cross
Fader A
2
Cross
Fader B
2
Cross
Fader B
2
Cross
Fader B
2
Cross
Fader B
2
Cross
Fader B
2
MIC
MIC MIC MIC MIC
Post CH1
Fader
2
— — — —
Post CH2
Fader
2
— — — —
Post CH3
Fader
2
— — — —
Post CH4
Fader
2
1 The audio data is output with the same volume at which it is input to this unit,
regardless of the [USB Output Level] setting.
2 When using for applications other than recording, pay attention to the DJ
application’s settings so that no audio loops are generated. If audio loops are
generated, sound may be input or output at unintended volumes.
! When there is a connection with Serato DJ, the CH5 setting cannot be changed
to other than [REC OUT] or [REC OUT (NO MIC)].
3 Click the [USB Output Level] pull-down menu.
Adjust the volume of the audio data output from this unit.
! The [USB Output Level] setting is applied equally to all audio data.
However, when 1 on the table at step 2 is selected, the audio data is
output with the same volume at which it is input to this unit.
! If not enough volume can be achieved with the DJ software’s volume
adjustment alone, change the [USB Output Level] setting to adjust
the volume of the audio data output from this unit. Note that the
sound will be distorted if the volume is raised too high.
Adjusting the buffer size (when ASIO is
used)
This function can only be used by those using a Windows operating
system.
If an application using this unit as the default audio device (DJ software,
etc.) is running, quit that application before adjusting the buffer size.
Display the setting utility before starting.
Click the [ASIO] tab.
! If the buffer size is made large, drops in audio data (breaks in the
sound) occur less easily, but the time lag due to the delay in the
transfer of the audio data (latency) increases.
Checking the version of the driver
software
Display the setting utility before starting.
Click the [About] tab.