User Manual

En
28
Disabling the demo mode
On this unit, the demo mode is set if no operation is performed for
10 minutes under normal usage conditions. This demo mode can be
changed.
! By default, demo mode starts when there is no operation for 10
minutes.
! When any control or button on this unit is operated while in the
demo mode, the demo mode is canceled.
Press one of the [SOUND COLOR FX] buttons.
! [ECHO] button lights: Demo mode is disabled
! [JET] button lights: Demo mode starts when there is no operation for
1 minute
!
[PITCH] button lights: Demo mode starts when there is no operation
for 5 minutes
! [FILTER] button lights: Demo mode starts when there is no operation
for 10 minutes
Changing the sampler velocity
mode’s velocity curve setting
Use the procedure below to set the sampler velocity mode’s velocity
curve. You can choose one of four types of velocity curves.
! By default, curve 3 is set.
Press one of the [AUTO LOOP] buttons on the deck
whose setting you want to make.
The velocity curve setting changes each time the [AUTO LOOP] button
is pressed.
The currently set value is indicated by how the [LOOP 1/2X], [LOOP 2X],
[LOOP IN] and [LOOP OUT] buttons light.
Curve 1
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 2
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 3
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Curve 4
MIDI
code
Strength which
performance pad is pressed
Min. Max.
Enabling the sampler velocity
mode’s after touch setting
When the sampler velocity mode is turned on for this unit’s performance
pads, the after touch setting can be turned on and off.
After touch setting disabled: The sampler volume changes according
to the strength with which the performance pad is initially pressed, but
does not keep changing while the pad is held after it is initially pressed.
After touch setting enabled: The sampler volume changes according to
the strength with which the performance pad is initially pressed and the
strength with which the pad is held after it is initially pressed.
! By default, the after touch setting is disabled.
Press the [SAMPLER] mode button on the left deck.
! [SAMPLER] mode button lit: After touch setting enabled
! [SAMPLER] mode button off: After touch setting disabled
Disabling the auto standby function
! When auto standby function is set to on, if 4 hours have passed while
the following conditions are all met, the unit automatically enters
standby status.
—
Buttons and controls of the unit except the [MIC1] control and
[MIC2] control are not operated.
— That no audio signals of -18 dB or greater are input to this
unit’s input terminals.
!
When the [PANEL (WAKE UP)] button is pressed, the standby mode
is canceled.
!
By default, the auto standby function is enabled.
Press the [KEY UP/SYNC] button of the left side deck.
! [KEY UP/SYNC] button lit: Auto standby function is enabled
! [KEY UP/SYNC] button off: Auto standby function is disabled
Changing the talk over function setting
About talk over mode
The talk over function has the two modes described below.
Advanced talk over mode: Sound other than the microphone channel is
output with only the midrange attenuated per the talk over level setting.
dB
Frequency
Normal talk over mode: Sound other than the microphone channel is
output attenuated per the talk over level setting.