Owner's manual

DataMan2
Operating Instructions
DataMan2_OI_104.doc Page 33 of 35
5.3 Command Action
The buttons under Command Action are to edit and test a command before saving the data.
The buttons consist of the following activities:
•
Play
– play back RS-232 lines items from the list (shown in the Command window to the
left) in sequence from top to bottom
•
Set Caret
– select the line item for the first action (move the cursor to directly in front of
the selected line item and click on Set Caret; playback will begin from that line)
•
Pause
– halt playback of the list but remain at the current line item
•
Step
– advance to the next line item on the list
•
Stop
– halt playback and return to the starting point (on line item 1 or at the caret point)
In additional to the buttons described above, a radio selector provides looping playback when
necessary. Click on the
Repeat OFF
selector to activate. Each time the command repeats,
the counter below the selector incrementally advances. The looping continues until the
command is halted or deactivated.