Manual

MAINTENANCE
CLEANING THE HEAD, PINCH ROLLER
AND CAPSTAN
The heads, pinch rollers and capstans are parts which ere liable to get
dirty quite easily In partlcular, if the heads are dirty, the high-
frequency components are not reproduced and the stereo balance is
impaired, resuitlng in a deterioration in the playback sound tt is
therefore recommended that the head section be cleaned regularly
1 Press the EJECT button and open the cassette door
2. Dip the cleaning swab into the cleaning fluid and use it to wipe the
heads, capstans and pinch rollers
CLEANING THE FRONT PANEL SECTION
Wipe the front panet and the cassette door when dusty or greasy with
a soft cloth containing a small amount of ordinary detergent
Then. wipe dry with a cloth Never use volatile spirits like thinners.
benzine or alcohol because they w_tl damage the panel's finish
I NOTE:
After cleaning, do not insert a tape until the cleaning liquid has
dried 12 to 3 minutes)
* Set the power switches of the connected equipments to OFF
DEMAGNETIZING THE HEADS
After using the cassette deck over a period of time. the heads wilf
become magnetized The same effect is also caused by bringing a
screwdriver, magnet or other magnetized object too near the heads
This causes foss of high-frequency sound during recording and
playback, and is atso a cause of interference noise The heads should
be regularly demagnetized with a head demagnetizer (eraser) which
can be purchased at your deater
When demagnetizing the heads, be sure the cassette deck's POWER
switch is in the STAND-BY positton For detailed instructions
consult, the operating manual for your head demagnetizer {eraser)
Pinch
Capstan
Combination head
Capstan
Pinch ro_ler
<RRB.276>