Manual

I TAPE COPYING (from DECK I to DECK II) I

• The tape copying function permits you to copy the contents of

a tape from DECK I to DECK 11.

• The SYNCHRO COPY button is used to select either normal

speed copying, or high-speed copying (copying at twice the

normal playback speed).

1. Load s tape for playback into DECK I and a tape for

recording into Deck II.

2. Set the REV MODE switch.

3. Set the tape transport direction.

• Tape copying is always performed in the direction indicated

by the tape transport indicator (1_or <1).To change this di-

rection, press the desired playback button (1_or <1),then im-

mediately press the stop (11) button.

4. Press the SYNCHRO COPY button to select either

NORMAL or HIGH speed.

NORMAL: Tape copying at normal speed allows listening dur-

ing playback (COPY indicator lights steadily).

HIGH: Tape copying at twice the normal be speed (COPY

indicator flashes). Playback will still be audible.

To stop copying

Press the stop (11) button of either deck. Both decks will stop.

NOTES:

• The tape in DECK II will be copied with the same type of

DOLBY NR as DECK rs tape, regardless of its own setting.

• ff a nearby television set is on whi/e high-speed copying is

being performed, a high-pitched interference sound may be

heard on the tape. In this case, either use the normal speed

copying function, or turn off the television.

• During high-speed copying, none of the opera,on buttons v_ll

function except for the stop (IE) button.

• During normal speed copying, the recording mute (O) and

pause ( I I ) buttons of deck II also function.

• Tape copying is cancelled when either of the two tapes reaches

the end. Therefore it is advisable to use tapes of the same

length.

• The sound quality of the copied tape will be somewhat less

than the original. Therefore when making more than one copy,

always record from the original tape (do not make a copy of a

copy).

• The recording level adjustment is not necessary during tape

copying.

<RRB1150>,