Manual

I
FRONT PANEL FACILITIES
OPERATION OF DECK [ WITH A REMOTE
I
CONTROL UNIT NOT DESIGNED FOR h
DOUBLE DECKS (System remote control)
I
Selecting DECK [
In order to operate DECK [ with the remote control unit, adjust the
unit as follows: With the power off, press and hold the stop (m) but-
ton of DECK l, and turn the power on. Continue to hold the stop (1)
button for approximately five seconds. DECK ] can now be operated
using the remote control unit, but DECK ]l cannot.
Switching to DECK ][
To restore remote control operation to DECK 11,press the stop (m)
button of DECK II while DECK II is in stop mode. DECK 11can now
be operated using the remote control unit. Remote control opera-
tion can be switched back and forth between decks by pressing
the stop button of the desired DECK while it is in stop mode,
NOTE:
ff a power failure or a sudden change in the power supply (caused by
lightning, etc.) occurs, the unit is reset to its original state. Only
DECK II can be ol_rated by remote control To restore operation to
either deck, repeat the above procedure from the beginning.
FUNCTION DISPLAY
(_) DECK ! counter indicator
Normally the tape counter or time counter is displayed (see
page 11). It flashes for 4 seconds after the power cord is con-
nected to the power supply.
(_ CD.DECK SYNCHRO indicator (CD SYNC)
This indicator lights steadily when the CD SYNC button is
pressed and the operation starts.
(_ FLEX Indicator (Except for U.S. model of CT-
W606DRI
This indicator lights when the FLEX button is pressed.
_) DECK ]1 counter indicator
Normally the tape counter or time counter is displayed (see
page 11). It flashes for 4 seconds after the power cord is con-
nected to the power supply.
(_ DECK I] tape transport mode indicators
See table entitled "TAPE TRANSPORTATION MODE INDICA-
TORS" on this page.
(_ DECK [I AUTO BLE XD indicator (Except for U.S.
model of CT-W606DR)
• See page 13.
(_) DOLBY NR BIC indicator
(_ Level meter
Holds peak for about 1.3 seconds.
The "e" mark beside the 0 dB mark indicates the Dolby NR sys-
tem standard level.
(_) Reverse mode indicator
(_ DECK ! tape transport mode indicators
See table entitled "TAPE TRANSPORTATION MODE INDICA-
TORS" on this page.
TAPE TRANSPORTATION MODE INDICATORS I
10
<RRB1176>
En
PI.AY _1_ < PI-AyREC _I_
These indicators display the current tape transport mode. The chart
below shows the meaning of each of these indicators. The indicators
for DECK ] and DECK [1 differ only in the location of the PLAY and
REC indicators (DECK l-left, DECK ll-right).
For both DECK ] and ]1 _:ZZI:_Flashing rapidly
Forward mode Reverse mode
Stop _1_
Playback PI.Ay _ ._ play
,.*J, ,_lf.
Fast forward "_,._,,._ "-,_ ,_
Fast reverse _-_'_ _ _ _'DI_
,,\ g /.. ,qJ,
Forward _ ....
music search , , _ - - _ _ ,
Reverse " " " ..... _1_ 41 - l=l.Ay _ _:
music search _",_,, "_ P_ .Y.(- ..... -,,.-
DECK II only E_ Flashing slowly
Forward mode Reverse mode
Playback pause PLAY _ _ PLAy
Recording IR_=C _1_ _ RmC
Recording
standby REC _ _ RISC
muteRecording _ I_ 41_