Manual

TROUBLESHOOTING
Symptom Cause Rmmedy
POOR SOUND QUAUTY
Jnstable or inter- • The Iwad, pinch milers end capstans ere
mpted sound.
No high frequen-
cies.
High frequencies
•re
emphasized.
dirty.
• Thetape is notuniformlywound.
• A tape recorded wlthout Dolby NR is
being played back with the DOLBY NR
switch in the B or C position.
• The head is dirty.
• A Dolby NR<_ncoded tape is being played
back with the DOLBY NR switch in the
OFF position.
• Cleanthe head (see page S).
• Completelyfast-forwardor rewind tbetapa.
• Set the DOLBY NRswitch to OFF.
• Clean the head (see page 5).
• Set DOLBY NR (B/C) switch to the same
position used for recording,
Sound from previ- • The head is dirty. • Clean the head (m page 5).
ous recordings
remsins when
rerecording a tape.
The sound is dis- • Recording level iston high. • Turn REC LEVEL control down when
torted, recording(see page 14).
• The recorded sign•l itself is distortad, • Repiacetheoassette.
• Thelwadisdlrty. • Cloen the heed (see page S).
Too much noise. • • Replace the cassette.
• • Check connections (see page 7),
High noise mpo is being used.
Incomplete insertion of • connection
cord, poor contact.
Recording level is ton low.
• The head Is dirty.
• The head is magnetized,
• Turn RECLEVELcor_rolup when record-
ing (see page 14).
• Cleen the heed (see F.=geS).
• Demagnetize with e heed demagnetizer
(see page 5).
OTHERS
The music search • Blanks between selections am less than 4 • Use a tape with blanks more than 4
function does not seconds long. seconds long.
work.
Cannot use the • The remote con_rol cord is not connected • Connect the ramofJ.=control cord
remote control (see page 7).
system,
Abnormai functioning of this unit may be caused by static etectTicity, or other external tn_rference. Torestore no/Trialoh"
eration, nJm the power o_ and then on again, or unplug the A Cpower cord and then/dug it in again,
17