Manual

PLAYBACK
SINGLE PLAYBACK (Either DECK I or
DECK II)
2 3
n '_'_m o_e et
q in I il I I L___/ I II I
1 5 15) (1)
1. Load a prerecorded tape in DECK I or II.
2. Set the DOLBY NR switch,
• Always set the switchto the same positionthat was used
for recording.
3. Set the REV MODE switch (see page 8).
4. Set the stereo amplifier for tape playback.
5. Press the playback II_ or <1)button of either DECK I
or II.
To stop playback temporarily(DECK II only)
Press the pause (11)button.
• To resume playback, either press the pause (11}button again, or
press the playback (_ or 4) button.
To stop playback
Pressthe stop(i) button.
NOTE:
When the play button (forward) is pressed during fast forward, the
unit will play back in the reverse direction, and then play back in the
forward direction. (vice versa for reverse)
Example: When I_ is pressed during fast forward:
Fast Forward
forward -._ stop --_ Reverse pley
(0.5 seconds) _ stop --_ play
REWIND AUTOPLAY ]
Rewind autopiay engaged when the REWIND AUTO PLAY button is
pressed.
Playback starts automatically when the tape is rewound completely.
BLANK SKIP
REV MODE
This function allows you to skip unrecorded portions of the tape dur-
ing playback.
Set the REV MODE switch to _--o.
NOTES:
• When the REVMODEswitch is set to the c",__position, the
relay mode will be selected.
• When this mode is selected, if the tape deck encounters an
unrecorded portion of tape more than t5 seconds in length, it will
fast forward the tape until it encounters another recorded portion,
and resume playback from that point.
10
<RRB1169>
En
RELAY PLAYBACK
When relay playback mode is selected, continuous playback can be
performed. When the tape in the first deck reaches its end and
stops, the other deck will automatically begin playback,
1. Load prerecorded tapes in DECK I and DECK II.
2. Set the DOLBY NR switch.
• Alwaysset the switchto the same positionsthat was
usedforrecording.
3. Set the REV MODE switch to cz._ (See table entitled
"PLAYBACK SEQUENCE WITH REV MODE SWITCH
SETTING" on this page).
4, Set the stereo amplifier for tape playback.
5, Press the playback (ib or <) button of the deck that
will start to play first.
• When thetape inonedeck ends,the otherdeckautomati-
callybegins playback.
• Tocancelrelayplayback,pressthe stop(11)button.
NOTES:
• Relay playback can begin from either DECK I or DECK II.
• The tape in the idle deck can be replaced during foley playback
mode, allowing many tapes to be played back oontinuousiy. This
is a convenient feature for parties, background music, etc.
• When this mode is selected, of the deck encounters an
unrecorded portion of tape more than 15 seconds in length, it will
fast forward the tape until it encounters another recorded portion,
and resume playback from that point.
To stop playback temporerily(Dack II only)
Press the pause (11)button.
• To resume playback, either press the pause (11)button again, or
press the playback (1_ or <1)button.
To stop playback
Pressthe stop(ll) burtonof the operatingdeck.
PLAYBACK SEQUENCE WITH REV MODE SWITCH
SETnNG
The playback sequence depends on the setting of the REV MODE
switch and on which playback (1_or _1) button is pressed first. The
playback sequence for each possible selection is shown below.
*2 In the repeat ( _ ) mode, relay playback always begins from the
forward direction,
I I:> : DECK I forward playback
I <1 : DECK I reverse playback
II I> : DECK II forward playback
II <1: DECK II reverse playback
_o : Auto-reverse function
--_ : Relay
REV Starting Other
MODE olayback deck Playback sequence
switch button mode
c'.._ DECK I1_ *2 Ib- ,_1<_,'11 t>. ,_,fl <1',_.1I> _,1_...
15 times relay (32 sides playback)
_',-_ DECK I.< *2 I<:1-_ II _.=11 <1-_ I I>ool <1-_ III:>...
15 times relay (31 sides playback)
DECK liP- *2 lid _=11<_-_1 Do= I .<_'11 I> =41 <L..
15 times relay (32 sides playbeckl
DECKII,4 *2 I1<_-_ I ¢>-_1<1--- II €>-.II<I --- I I>...
15 times relay (31 sides playback)