Owner's Manual

Updating the firmware

Important

! Cannot be updated if the unit is using batteries. Connect the unit to an AC adaptor, and update after connecting the unit to a PC.

! Do not in any circumstances unplug the power cord until “Update completed.” is displayed when the firmware is being updated in accordance with

the 7 steps below.

! Firmware updates may take more than the time described below depending on your network environment.

1 Turn on the PC and launch the MIXTRAX.

2 Connect the AC adapter to the device and turn the power on.

3 Use the supplied USB cable to connect the PC to the ‘PC connect’ terminal on rear panel of this device.

4 Press the “Check for updates.” button on MIXTRAX.

5 Operate according to the instructions displayed on the MIXTRAX screen.

“Preparations for the update of the device’s firmware is complete.” will be displayed on the MIXTRAX screen.

6 Remove the device from the PC.

When removing the device from the PC, do so according to the correct way for removing USB devices from PCs.

7 The device’s firmware update will start. Please wait.

Do not unplug the power cord until the firmware update is completed.

! The unit will restart automatically during update.

! Update progress can be confirmed with the power indicator (LED) and the indication on the display.

 <Unit while firmware being updated> LED Display



Checking firmware flashing “Updating the software. Never unplug the power cord.”

 ↓(May take about 10 minutes)

 Updating flashing off

↓(May take several minutes)

 Update completed on “Update completed.”

8 Firmware update is completed.

If the power indicator lights up and “Update completed.” is displayed, the unit’s firmware update has been successful.