Manual

ManualsBrandsPioneer ManualsVideo EquipmentOfficial Pioneer dvd system

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this

component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and

electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your

nearest PIONEER authorized service center or your dealer to carry out repair work.

Common to LD and CD

Symptom Possible Causes Reference Page

Operation 1. Thedisccomesoutevenwhen • The disc is dirty or warped, p. 7, 12

the disc table is closed. • The disc is not placed properly on the disc table, p. 6

• Condensation formed inside the player, p. 4

Remote control 2.

Audio

Remote control operation is not

possible.

3. Improper operation of TV set,

etc., occurs.

4. Audio is not output or distorted.

• The control input jacks are in use.

• The remote control unit is too far from the

player.

• The batteries are exhausted.

Improper operation may occur with some TV

sets.

• The connection between the player and amplifier

is erroneous or the plugs are not inserted fully

into the jacks.

• The connection plug of the jack is dirty.

• The player is in pause mode.

• A wrong input is selected on the amplifier.

_> Refer to the operating instructions of the

amplifier.

• The audio output is connected to the PHONO

input jacks of the amplifier.

p. 8,9

p. 5

p. 8,9

p. 12

p. 8,9

Possible Causes

Video, picture

quality

Audio (LD)

Symptom

TV programs cannot be viewed.

The video cannot be viewed,

the picture quality is poor or

noise interferes with the video.

7. A part of the still frame image

shakes.

8. Audio sound is undulating.

9. Audio is not output.

• The VHF antenna is not connected.

• The power of the player is left on.

• A cable supplying the mixed signal of VHF and

UHF signals is connected to the adapter.

• The disc is dirty or warped.

• The power of the TV is turned off.

• The connection is erroneous or the plugs are not

inserted fully into the jacks.

• The still frame image may shake if it shows a

dynamic scene.

• A disc which does not carry the CX mark is

played while the CX system is ON.

• The player is in the multi-speed, still frame or

frame-by-frame advance mode.

Reference Page

3.8,9

p. 7

p. 8,9

p. 13