Manual

TROUBLESHOOTING
SYMPTOM
13. Certain discs take too long to
start or do not start.
14. The player takes too long to
find point A during A-B
(INTERVAL) REPEAT operation.
15. Picture other than instructed is
searched in TIME NUMBER
SEARCH mode.
CAUSE
There are errors when the disc code is
read (There is no damage to the unit).
• Same as item 12 above.
REMEDY
• Press • and stop the playback. Press PLAY =,-
and start the playback again. (Repeat this
operation a few times.)
• Same as item 12 above.
(The repeat mode is cancelled).
• Method of inputting numerals in the TIME NUMBER SEARCH mode differs, depending on
whether time number is recorded on disc in hours and minutes or minutes and seconds, as
shown below:
[e.g.] 12-minute search
• Disc in which time number is recorded in hours and minutes
"minutes"
• Disc in which time number is recorded in minutes and seconds
"minutes .... seconds"
WHEN PLAYING BACK A COMPACT DISC
SYMPTOM
16. Player stops immediately
after playback is started.
17. No sound output
18. Sound is distorted.
CAUSE
• Disc is loaded upside down (CD, CDV,
onesided LD discs).
• The playing surface of the disc is dirty.
• Disc is not properly set on the disc table.
• The stereo amplifier is not correctly
connected.
• You are not operating the stereo amplifier
correctly.
• The connection terminals and/or the plugs
of the connection cords are dirty.
• The plugs of the connection cords are
disconnected, or are not fully pushed in.
• The player is in pause mode.
• The audio output jacks are connected to the
PHONO iacks.
• The connection terminals and/or the plugs
of the connection cords are dirty.
• The plugs of the connection cords are not
fully pushed in.
REMEDY
Load the disc correctly with the label side
upward.
Use a soft cloth and lightly wipe off the dirt
from the surface of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
Set the disc properly.
Connect the amplifier correctly.
Refer to the operating instructions for the
amplifier, and operate the amplifier correctly.
Clean the plugs and terminals and connect
again.
Make sure that connections are made
correctly.
Press PLAY _- and restore the player to play
mode.
• Connect to the AUX, CD, VDP, LD or VCR
jacks.
• Clean the plugs and terminals and connect
again.
• Push the plug in firmly.
42
<VRB1142>