Manual

j PRECAUTIONS
If it becomes necessary to transport Or ship this unit in the
future, be sure to first remove the disc (if loaded), and retract
the disc table to its closed position. Then turn the power off,
and, after the 'OFF" display stops blinking on the display, dis-
connect the power cord.
When FM or AM stations are being received, signal noise may be
generated if the player is turned on. Turn off the player when not
in use. Also, if there is signal noise when receiving radio stations
with an indoor antenna, adjust the position or direction of the
antenna.
INSTALLING THE PLAYER
• Place the player on a stable platform next to the television and
stereo system to be used with the player.
• Do not place heavy objects such as a television or TV monitor
on top of the player.
• Do not place the player on top of your TV set or TV monitor.
Also, keep the player away from devices such as cassette decks
which are sensitive to magnetic fields.
DO NOT INSTALL THE PLAYER IN THE FOLLOWING
LOCATIONS
• In a place subject to direct sunlight.
• In humid or poorly ventilated places.
• In extremely hot or cold places.
• In a place subject to vibrations.
• In a dusty place.
• In a place subject to soot, steam or heat (in a kitchen, etc.)
AVOID SOURCES OF HEAT
Do not put the player on sources of heat, such as an amplifier.
When installing with audio components that generate heat, by
placing the player below such components where there is ade-
quate ventilation and not much dust. Avoid placing the player on
surfaces such as shaggy carpets, beds, and sofas which may block
ventilation under the player and cause damage.
CAUTION
Even when the player is in the pause mode, the disc-drive motor is
still revolving. Since leaving the player in this condition can shorten
the lifetime of the motor, do not leave the player in the pause
mode for long periods of time. Also, to prevent damage to the
screen, do not use the unit for long periods of time under condi-
tions in which the screen display (monitor) is displaying characters
(for example, power-ON mode, CD PLAYER, PAUSE) With an LD
disc, if playback is paused for about 20 minutes, the player will
automatically enter stop mode.
STRIPE PATTERNS APPEARING ON A TV PROGRAM
Stripe patterns may appear during a TV program if the player unit is
turned on, depending on the quality of reception of the TV station.
This is neither a malfunction of the television nor the player. If
stripes appear while watching the TV, or whin watching the -IV for
long periods of time, turn the player off.
CONDENSATION
Moisture will form in the operating section of the player if the
player is brought from cool surroundings into a warm room or
if the temperature of the room rises suddenly. When this hap-
pens, player's performance will be impaired.
To prevent this, let the player stand in its new surroundings
for about an hour before switching it on, or make sure that
the room temperature rises gradually.
Condensation may also form during the summer if the player is
exposed to the breeze from an air conditioner. In such cases,
change the location of the player.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your hands
are wet as this could cause a short circuit or electric shock. Do not
place the unit, a piece of furniture, etc., on the power cord, or
pinch the cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed in such a way that they
are not likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power cord once in
a while. When you find it damaged, ask your nearest PIONEER
authorized service center or your dealer for a replacement.
I CLEANING CARE I
Use a soft, dry cloth for cleaning. For stubborn dirt, soak the cloth
in a weak detergent solution; wring well first and wipe. Use a dry
cloth to wipe it dry. Do not use any volatile agents such as benzine
or paint thinner, as they may damage the surface of the player.
Abnormal functioning of this unit may be caused by static
electricity or other external interference. To restore normal
operation, unplug the AC power cord and then plug it in
again.
Only one disc can be loaded at any one time. Loading a Laser-
Disc, a Compact Disc, a 3-inch (8-cm) Compact Disc or a Com-
pact Disc with Video on top of one another may result in a
breakdown, or in scratching of the discs. Please only load one
disc at a time.
This player is to be used exclusively with the NTSC color
system. Please use an NTSC LaserDisc only. PAL and SECAM
system discs cannot be used with this player.
4
<VRB 1148>