Owner's Manual

CConnections )
Section
C ) C!D
~Important
• Use this unit in other than the following cond i-
tions could result in fire or malfunction.
- Vehicles with a 12-volt battery and negative
grounding.
•
To prevent short-circuit, overheating or mal-
function,
be sure to follow the directions
below.
- Disconnect the negative terminal of the
battery before installation.
- Secure the wiring with cable clamps or
ad-
hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.
- Place all cables away from moving parts,
such
as gear shift and seat rails.
- Place all cables away from hot places,
such
as near the heater outlet.
-
Do not pass the yellow cable through a
hole into the engine compartment to con-
nect to a battery.
-
Do not shorten any cables.
- Never
cut the insulation of the power cable
of this
unit in order to share the power to
other equipment. Current capacity of the
cable is limited.
- Use a fuse of the rating prescribed.
• IP-BUS connectors are color-coded.
Be sure
to connect connectors of the same color.
• Place antenna cable
as far away as possible
from the other cables to prevent noise.
• Black cable is ground. This cable and other
product's ground cable (especially, high-cur-
rent products such
as power amp) must be
wired separately. Otherwise, fire or malfunc-
tion may result if they are accidentally
de-
tached.
•
Do not connect anything other than the USB
portable audio player/USB memory.
• Plug the terminal of the USB portable audio
player/USB memory firmly into the connector
to connect, otherwise this unit may not work
properly
or an error may be displayed on the
head unit.
En ®