User manual

Vibration detected. Please
power off the system and
check the installation. Then,
please re-boot the system and
press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a place where
the unit will not be affected by vibration.
Direction of G sensor is not
correct. Please power off the
system and check the installa-
tion. Then, please re-boot the
system and press “OK”.
Direction of G sensor is set incor-
rectly.
See the Installation Manual and set the direc-
tion of the navigation unit correctly.
Gyro Sensor is not working
properly. Please consult your
dealer or Pioneer service cen-
ter.
Abnormal Gyrosensor output is de-
tected.
Write down the error code shown on the
screen. Turn off the power, and then contact
your nearest Pioneer service facility.
Positioning is not possible
due to the hardware. Please
contact your dealer or Pioneer
service center.
The location display is not possibl e
due to hardware failure.
Consult your dealer.
GPS antenna problem de-
tected. Please contact your
dealer or Pioneer service cen-
ter.
The location display is not possibl e
due to failure of the GPS antenna.
Consult your dealer.
This function is currently una-
vailable.
The screen cannot be displayed with
Vehicle Dynamics Display. The sen-
sor has not been taught so the sen-
sor information cannot be acquired.
If the sensor learning status reaches the Sen-
sor Initializing, the system is ready to be
used.
The vertical installation angle
is changed. Gyro Sensor cali-
bration is re-initialized.
If the mounting angle of the naviga-
tion unit has been changed.
The system initializes the sensor in order to
operate it with the maximum performance
and automatically starts re-learning.
Excess vertical installation
angle detected. Please install
the navigation unit correctly.
The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle.
Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details refer to
Installation Manual.)
No data available at this time. No data is available that can be
used with the XM tuner.
Wait for a while and try the operation again.
UPDATING (Updating) The selected channel is not in-
cluded in your subscription.
Select another channel.
Radio is being updated with the lat-
est encryption code.
Wait until the encryption code is fully up-
dated.
Route calculation was not
possible.
Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware.
! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persis ts.
Route calculation not possible
because desti nation is too far.
The destination is too far. ! Set a destination closer to the starting
point.
! Set one or more waypoints.
Route calculation not possible
because desti nation is too
close.
The destination or waypoint(s) are
too close.
Set a destination and waypoint(s) farther
from the starting point.
Appendix
En
180
Appendix