User manual

Dialing is not possible because
the touch panel keys for dialing
are inactive.
Your phone is out of range for ser-
vice.
Retry after entering within range for service.
The connection between cellular
phone and the Bluetooth unit (sold
separately) (navigation system) can-
not be established now.
Perform the connection process.
The cellular phone is not registered
to the navigation system yet.
To use the cellular phone featuring the Blue-
tooth wireless technology with this navigation
system, the registration process is necessary.
When the screen is frozen...
Park your vehicle in a safe place, and cut off
the engine. Turn the ignition key back to “Acc
off”. Then start the engine again, and turn the
power to the navigation system back on. If this
does not solve the problem, press RESET but-
ton on the navigation system.
Messages and How to React to Them
The following messages may be displayed by your navigation system.
p There are occasions when you may see
error messages other than those shown
here. In such a case, follow the instructions
given on the display.
Messages for navigation functions
Message When What to do (See)
Irregular speed pulse signal
detected. Please power off
the system and check the in-
stallation. Then, please re-
boot the system and press
“OK”.
If the Navigation system does not re-
ceive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse not connected.
Calibration will start without
speed pulse. Accuracy is not
fully ensured without speed
pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, connect the
speed signal input (pink lead wire) of the
power cable correctly.
Although it can be operated with Simple hy-
brid mode without connecting the speed sig-
nal input, the precision of the positioning will
be less accurate.
Appendix
En
179
Appendix
Appendix