User manual

The daylight display is used
even when the vehicle lights are
on.
[Day] is selected to [Day/Night Dis-
play].
Check [Day/Night Display] setting and make
sure [Automatic] is selected. (Page 50)
The orange/white lead is not con-
nected.
Check the connection.
The display is very dim. The vehicle’s light is turned ON, and
[Automatic] is selected on [Day/
Night Display].
Read about [Day/Night Display] setting and,
if desired, select [Day]. (Page 50)
The vehicle cabin temperature is ex-
tremely low.
A Liquid Crystal Display (LCD) is used, and
such displays tend to darken when cold. Wait
for the vehicle to warm up.
Picture quality adjustment of the
display is not correct.
Adjust the picture quali ty. (Page 153)
Display tilt is not at the proper set-
ting.
Press and hold EJECT button to adjust the tilt.
No sounds are heard.
The volume level will not rise.
The volume level is low. Adjust the volume level.
The attenuator or mute is on. Turn the attenuator or mute off.
The speaker lead is disconnected. Check the connection.
The volume of beeps and naviga-
tion guidance cannot be ad-
justed.
You cannot adjust these parameters
with VOL (a/b) button.
Turn the volume up or down with [Volume]in
[Settings]menu.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible.
You cannot adjust them with VOL
(a/b) button.
Turn the volume up or down according to [Vo-
lume]in[Settings] menu. (Page 88)
A strange sound is heard when
the vehicle comes close to a cer-
tain place (e.g. Dog barking).
The sound for the entry of [Address
Book] is set.
Set the sound setting of that entry to [No
Sound]. (Page 63)
An alarm sounds when you ap-
proach the registered location
and the set image pops up, re-
gardless of whether [Address
Book Icon] is set to [Off].
This is a normal operation and not a
malfunction.
To turn off the sound output and image pop
up, select [No Sound] and [No Picture].
Slope is not displayed on Vehi-
cle Dynamics screen.
“Inclination” does not move on
3D Calibration Status screen.
The speed pulse lead is not con-
nected.
Connect the speed pulse lead.
No sound, no voice.
has been set, or sound volume
is reduced to 0.
Adjust the volume of the guidance or turn
off. (Page 88)
The person on the other end of
the phone call cannot hear the
conversation due to an echo.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
The registered phone cannot be
deleted.
Normally, the registered phone can-
not be deleted.
! Overwrite the old registered phone with a
new phone.
! Clear [Phone Settings]. (Page 187)
Appendix
En
176
Appendix