User guide

07
62
En
Others
Software updating is slow. Depending on the Internet connection and other conditions, some time
may be required to update the software.
• “WRT NG ****” is displayed
on the front panel display
during software updating.
(**** meaning any
characters)
• “WRT FAILED” is displayed
on the front panel display
during software updating.
The message is displayed when software updating has failed. Check
again whether it can be updated properly.
A message other than
“Network connection test
completed successfully” is
displayed when Connection
Test is performed.
Is “LAN cable not connected”
displayed?
Check that this player and Ethernet hub (or router with hub
functionality) are properly connected.
• Is “IP address cannot be
obtained.” displayed?
• Is “No response from the
gateway.” displayed?
• If the IP address is obtained using the DHCP server function, check
the setting is correct at the Display Network Configuration
(page 44). For details on the DHCP server function, see the operating
instructions of the Ethernet hub (or router with hub functionality).
• Set the IP address manually.
Is “IP address is overlapped.”
displayed?
• Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the DHCP
server function, see the operating instructions of the Ethernet hub (or
router with hub functionality).
• If this player’s has been set manually, reset the IP address of this
player or other components.
Is the Ethernet hub (or router
with hub functionality)
operating properly?
• Check the settings and operation the Ethernet hub (or router with hub
functionality). For details, see the operating instructions of the Ethernet
hub.
• Reboot the Ethernet hub (or router with hub functionality).
Problem Check Remedy
The player’s power turns off
automatically.
Is Auto Power Off set to
On?
If Auto Power Off is set to On, the player’s power turns off
automatically if no operation is performed for over 30 minutes
(page 41).
Is Display Power Off set to
On?
The player’s power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player’s
power to turn off when the TV’s power is turned off, set Display Power
Off to Off (page 39).
The
player’s power turns on
automatically.
Is KURO LINK set to On?The player’s power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player’s
power to turn on when the TV’s power is turned on, set KURO LINK to
Off (page 39).
Player cannot be operated
with remote control.
Is an AV receiver or amplifier
connected to the CONTROL
IN terminal on the player’s
rear panel?
Operate with the remo
te control of the device connected to the
CONTROL IN terminal.
Are you operating the remote
control from a point too far
away from the player?
Operate from within 23 feet (7 m) of the remote control sensor.
Are the batteries dead? Replace the batteries (page 7).
Input of connected TV and AV
system switches
automatically.
Is KURO LINK set to On?The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set KURO LINK to Off (page 39).
“Processing failed.” is
displayed.
If the message appears repeatedly, please ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem Check Remedy
320_UXJCA_EN.book 62 ページ ２００９年２月１３日 金曜日 午後４時２６分