User guide

17
En
02
video deck. Furthermore, the picture may not be
displayed properly due to the copy protection when
the player is connected to a TV with a built-in video
deck. For details, contact the manufacturer of your
TV.
Note
•Video signals are output with a resolution of 480/60i
when connected using a video cable.
• When connected to the TV using a component video
cable, video signals are not output with a resolution of
1080/24p or 1080/60p.
•Depending on the output video resolution setting, the
picture may not be output (page 22).
Connecting an AV receiver or
amplifier using audio cables
When connecting to a 7.1-channel compatible AV
receiver or amplifier – Connect using 4 audio cables
(diagram below).
When connecting to a 5.1-channel compatible AV
receiver or amplifier – Connect using 3 audio cables (do
not connect to the surround back left and right
terminals).
• To switch the video from the AV receiver or amplifier,
also connect the video output terminals.
•After connecting, set Audio Output Mode to Multi-
channel (page 38).
Note
• To connect to the 2-channel audio input terminals on
a TV, etc., connect to FRONT (L/R).
Connecting components
to the USB port
The data downloaded with the BD-LIVE function and the
data used with the BONUSVIEW function when playing
BD-ROMs can be stored on a device connected to the
USB port (external storage).
About USB (external storage)
devices
The USB (external storage) devices that can be
connected to the player are as shown below.
•USB 2.0-compatible memory devices or hard disks
• FAT16 or FAT32 file system, minimum 1 GB capacity
(2 GB or more recommended)
Note
• Devices formatted with a file system other than the
above cannot be used. Such devices may however be
usable if they are formatted from the player.
•External storage devices may not be recognized if
they contain multiple partitions.
• Some external storage devices may not operate with
this player.
•Operation of external storage devices (USB memory
devices, external hard disks, etc.) is not guaranteed.
AUDIO OUT(7.1 ch)
CONTROL
IN
VIDEO
OUT
VIDEO
FRONT SURROUND SURROUND
BACK
COMPONENT VIDEO
CENTER SUB WOOFER
L
Y
P
B
P
R
R
L
R
AUDIO OUT(7.1 ch)
CONTROL
IN
VIDEO
OUT
VIDEO
FRONT SURROUND SURROUND
BACK
COMPONENT VIDEO
CENTER SUB WOOFER
L
Y
P
B
P
R
R
L
R
TV
Player’s rear panel
To component
video input terminals
A component
cable or three
commercially
available video
cables can be
used instead of
the video cable
(yellow plug) of
the included
video/audio cable
for connection.
Direction of signal flow
Red
White
It is also possible to connect to
an AV receiver or amplifier.
Connect the audio signals
using audio cables (7.1
channels) or an optical digital
audio cable (below).
To video/audio
input terminals
Video/audio cable (included)
Yellow
AUDIO OUT(7.1 ch)
DIGITAL
OUT
CONTROL
IN
VIDEO
OUT
OPTICAL
VIDEO
FRONT SURROUND SURROUND
BACK
COMPONENT VIDEO
CENTER SUB WOOFER
L
Y
P
B
P
R
R
L
R
Player’s rear panel
To multi-channel audio
input terminals
AV receiver or
amplifier
Video/audio cable (included)
Red
White
Audio cable (commercially
available)
Direction of signal flow
An optical digital audio cable (commercially available) can also be used for connection.
To optical digital
audio input
terminal
Audio cable (commercially
available) Audio cable (commercially
available)
320_UXJCA_EN.book 17 ページ ２００９年２月１３日 金曜日 午後４時２６分