User Manual

Connecting28
En
Connecting
2
Wall mounting the speaker for
BCS-HW929
Before mounting
• Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling.
Make sure that the wall you intend to mount
the speaker on is strong enough to support
them. Do not mount on plywood or soft
surface walls.
• Mounting screws are not supplied. Use
screws suitable for the wall material and
support the weight of the speaker.
Caution
• If you are unsure of the qualities and strength of
the wall, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
1. Remove the base plates.
The base plates are held in position by the
useof2-sidedtape.Whileholdingthelegin
place, strongly press the base plate in the
direction indicated by the arrow to remove
the base plate. Be careful not to damage
the front speaker while doing this.
Base plate
Leg
2. Use a Phillips screwdriver to remove the
two screws holding the legs to the speaker.
3. Using the two screws removed in step 1,
fasten the wall mounting fixtures to the
speaker.
4. Affix the supplied wire stays to the top of the
unit as shown and collect the cable there.
Press until a “click” is
heard.
5. Mount on wall.
Wall
mounting
screws
(available
commercially)*
* Wallmountingscrewsarenotincluded.Purchase
appropriate screws taking into consideration the
type of wall and the weight of the speaker system.
Open two holes in the wall 818 mm apart.
6 mm to 8 mm