Car Video System User Manual

<ENGLISH>Connecting the Units
Multi-Channel AV
Master Unit (e.g. AVM-P9000R)
(sold separately)
Gray
Green
Gray
RCA cable (supplied with
the DVD player)
Blue
Yellow
(DVD VIDEO IN)
IP-BUS cable
(supplied with the Multi-Channel
AV Master Unit)
Optical cable
(supplied with the Multi-
Channel AV Master Unit)
3m
Black
Green
20 pin cable
(supplied)
Blue
Red
RCA cables (sold separately)
Green
Red
To audio outputs
To video output
RGB cable
(supplied with the Multi-
Channel AV Master Unit)
Red
Yellow
White (Left)
Red (Right)
AV cable
(supplied with the Multi-
Channel AV Master Unit)
Connection box
(supplied with the DVD
Navigation Unit)
DVD Navigation Unit
(e.g. AVIC-9DVD)
(sold separately)
This product
Voice guidance speaker
(supplied)
3m
DVD player
(e.g. SDV-P7)
(sold separately)
Red
Not used.
Blue
40 cm
Yellow (front
video output)
Yellow/black
To Yellow/black lead
(GUIDE ON)
on the navigation unit.
STAND ALONE
IP-BUS
Normally, connection is not
necessary.
If the DVD player (e.g. SDV-
P7) is installed in a location
that prevents reception of the
remote control signal, connect
with a separately sold AV-BUS
extension cable. (Or connect a
separately sold remote sensor
to the DVD player.)
When Connecting the Multi-Channel AV Master Unit
Fig. 3
3m
Green
20 pin cable
(supplied)
Red
RCA cable
(sold separately)
To video output
Yellow
(VIDEO INPUT)
Connection box
(supplied with the DVD
Navigation Unit)
DVD Navigation Unit
(e.g. AVIC-9DVD)
(sold separately)
This product
Voice guidance speaker
(supplied)
3m
Red
15 cm
To audio outputs
RCA cable
(sold separately)
To audio inputs of car stereo
When Connecting the Navigation Unit
Fig. 4
Installation <ENGLISH>
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connected
up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifications
of the vehicle.
• Install the unit where it does not get in the driver’s
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• Do not place the display in a position where it will
impede the driver’s visibility or affect the opera-
tion of your vehicle’s air bags.
• If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 5)
Fig. 5
30°
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN Front-mount) or
“Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush
1. Remove the frame. (Fig. 6)
Fig. 6
Frame
Pull out to remove the frame.
(When reattaching the frame, point the
side with a groove downwards and
attach it.)