User manual

77En
English
problem, contact your dealer or an
authorised Pioneer Station for
assistance.
Positioning is not possible due to
hardware error. Please consult your
dealer or local authorised service centre.
→ The location display is not possible due
to hardware failure.
–Contact your dealer or an authorised
Pioneer Station for assistance.
No GPS antenna. Check connection.
→ GPS reception is lost.
–Check the aerial connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or an authorised Pioneer
Station for assistance.
GPS antenna problem detected. Contact
dealer or service center.
→ GPS aerial lead is short-circuited.
–Contact your dealer or an authorised
Pioneer Station for assistance.
Calibration will start, but may be
inaccurate without speed pulse.
→ The speed pulse sensor is not
connected correctly.
–Contact your dealer or an authorised
Pioneer Station for assistance.
Sensor error. Please contact your dealer
or Pioneer Service Center.
→ An error has occurred with the sensor.
–Contact your dealer or an authorised
Pioneer Station for assistance.
Detected unusual speed pulses.
→ The speed pulse cannot be detected
correctly.
–Contact your dealer or an authorised
Pioneer Station for assistance.
Detected changes in the installation
angle or position. The in-dash receiver is
updating the sensor learning data.
→ Changes in the installation angle or
position are detected.
–Wait until the sensor learning finishes.
Speed pulse wire is not connected. The
system will operate in simple hybrid
mode.
→ Speed pulse wire is not connected.
–The speed pulse cannot be detected if
the speed pulse wire is not connected
correctly.
Check Antenna
→ The aerial connection is incorrect or an
unusual voltage has been detected.
–Turn the ignition switch OFF and
connect the aerial correctly. After
connecting, turn back ON again.
Error-02-XX/FF-FF
→ The disc is dirty.
– Clean the disc.
→ The disc is scratched.
–Replace the disc.
→ The disc is loaded upside down.
–Check that the disc is loaded correctly.
→ There is an electrical or mechanical
error.
–Press the RESET button.
Different Region Disc
→ The disc does not have the same region
number as this product.
–Replace the DVD with one bearing the
correct region number.
DAB tuner
Disc
Z910DAB
Z810DAB
Z710DAB
Z7110DAB
Unplayable Disc
→ This type of disc cannot be played on
this product.
–Replace the disc with one that can be
played on this product.
Unplayable File
→ This type of file cannot be played on this
product.
–Select a file that can be played.
Skipped
→ The inserted disc contains DRM
protected files.
–The protected files are skipped.
Protect
→ All the files on the inserted disc are
embedded with DRM.
–Replace the disc.
This DivX rental has expired.
→ The inserted disc contains expired DivX
VOD content.
–Select a file that can be played.
Video resolution not supported
→ Files that cannot be played on this
product are included in the file.
–Select a file that can be played.
Unable to write to flash memory
→ The playback history for VOD contents
cannot be saved for some reason.
–Retry.
–If the message appears frequently,
consult your dealer.
Your device is not authorized to play this
DivX protected video.
→ This product’s DivX registration code
has not been authorised by the DivX
VOD contents provider.
–Register this product to the DivX VOD
contents provider.
Video frame rate not supported
→ DivX file’s frame rate is more than 30 fps.
– Select a file that can be played.
Audio Format not supported
→ This type of file is not supported on this
product.
– Select a file that can be played.
SD function is only available for AVIC-
Z910DAB/AVIC-Z810DAB.
Error-02-9X/-DX
→ Communication failed.
–Turn the ignition switch OFF and back
ON.
–Disconnect the USB storage device.
–Change to a different source. Then,
return to the USB storage device.
Unplayable File
→ There is no playable file in the external
storage device (USB, SD).
–Check that the files in the external
storage device (USB, SD) are
compatible with this product.
→ Security for the connected external
storage device (USB, SD) is enabled.
–Follow the external storage device
(USB, SD) instructions to disable
security.
Skipped
→ The connected external storage device
(USB, SD) contains DRM protected files.
–The protected files are skipped.
Protect
→ All the files on the connected external
storage device (USB, SD) are embedded
with DRM.
–Replace the external storage device
(USB, SD).
External storage device (USB,
SD)