Operation Manual

— When the navigation outputs the gui-
dance voice.
— When you use a mobile phone via
Bluetooth technology (dialling, talking,
incoming call).
— When the voice recognition mode is ac-
tivated.
! Tel/VR: The volume is muted or attenuated
according to the following conditions.
— When you use a mobile phone via
Bluetooth technology (dialling, talking,
incoming call).
— When the voice recognition mode is ac-
tivated.
! Off: The volume does not change.
AVIC-F930BT, AVIC-F9310BT
! Guide/Tel: The volume is muted or attenu-
ated according to the following conditions.
— When the navigation outputs the gui-
dance voice.
— When you use a mobile phone via
Bluetooth technology (dialling, talking,
incoming call).
! Tel: The volume is muted or attenuated
when you use a mobile phone via Bluetooth
technology (dialling, talking, incoming call).
! Off: The volume does not change.
p AV source volume returns to normal when
the corresponding action ends.
Switching the muting/
attenuation level
You can select the muting/attenuation level of
“Mute”. This setting is also effective for a
mute signal that has been received from the
MUTE lead connected to the navigation unit.
p This menu is not available when AV source
is “Off”.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 147.
2 Touch [Mute Level].
Each touch of [Mute Level] changes the set-
tings as follows:
! 20dB: The volume becomes 1/10.
! 10dB: The volume becomes 1/3.
! All: The volume becomes 0.
p When you select “All”, no audio adjust-
ments are possible during the sound is
turned off.
p When you select “20dB” or “10dB”,no
audio adjustments are possible during the
sound is attenuated.
p AV source volume returns to normal when
the corresponding action ends.
p Even when a mute signal has been received
from MUTE lead connected to the naviga-
tion unit, navigation voice guidance cannot
be attenuated or muted.
Switching Auto PI seek
The navigation system can automatically
search for a different station with the same
programming, even during preset recall.
p “Auto PI” can be set only when the source
is selected to “Off”.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 147.
2 Touch [Auto PI].
Each touch of [Auto PI] changes the settings
as follows:
! Off (default):
Deactivates the Auto PI seek function.
! On:
Activates the Auto PI seek function.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When “AF” or “TA” is
on, the tuning step automatically changes to
100 kHz. But you can set the tuning step to
50 kHz when “AF” or “TA” is on.
Engb
150
Chapter
26
Customising preferences