Hardware manual

Chapter 1

Setting the Remote Control and Names of Each Part

Setting and removing the disc

Insert the disc to the disc slot with the label-side up. To remove the disc, press the disc eject

button on the right-hand side of the disc loading slot.

➲ Do not try to use discs other than a disc designed for this system. Please use only the disc

speciﬁed by Pioneer. (For playing the DVD-video Audio-CD, see Chapter 2 “Using Built-in

DVD Player (AVIC-9DVD— only)” on page 21.)

➲ Do not attempt to use discs that are cracked, scratched, bent, or otherwise damaged.

➲ Treat your disc carefully. See “Handling and Care of the Disc” on page 47 for advice on

proper handling and use.

➲ After removing the disc from the slot, keep it in the case.

Setting the PC card

Open the cover at the front of the main unit. Hold the PC card label-side up: the arrow shows

the direction of insertion. Insert the card ﬁrmly until the PC card eject button pops out. If the

main unit power is on, the PC card lock lamp changes from green to red, showing that the PC

card is inserted correctly and ready for use.

Removing the PC Card

Open the cover on the front of the main unit. Slide the PC card lock lever to the right (1), and

hold it there. Check that the PC card lock lamp has changed to green, and then press the PC

card eject button (2). (Keep holding the PC card lock lever to the right until the PC card is

removed completely.)