Hardware Manual ENGLISH DVD Navigation Unit AVIC-88DVD
Introduction Selecting fine audio equipment such as the unit you’ve just purchased is only the start of your musical enjoyment. Now it’s time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
Manual Overview Terminology This manual mainly describes hardware-related information such as the part names of the Navigation System or precautions for use. Please read this manual and all other enclosed manuals before using your Navigation System. The following issues are described in each chapter: Before moving on, take a few minutes to read the following information about the conventions used in this manual.
Table of Contents Important Safety Information Introduction Before using your Navigation System, be sure to read and fully understand the following safety information: • Read the entire manual before operating this Navigation System. • The navigation features of this unit are intended solely as an aid to you in the operation of your vehicle. They are not substitutes for your attentiveness, judgment, and care when driving.
• Do not install the display and the navigation unit where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle. • Please remember to wear your seat belt at all times while operating your vehicle. If you are ever in an accident, your injuries can be considerably more severe if your seat belt is not properly buckled.
to use these functions during driving, it may be inoperable. If so, stop in a safe place, apply the parking brake, then operate. Product registration Visit us at the following site: To avoid battery exhaustion Be sure to run the vehicle engine while using this unit. Using this unit without running the engine can result in battery drainage. About voice guidance There may be no voice guidance depending on a combined unit (e.g. multi-channel proccessors).
6
Chapter 1 How to Use Remote Control and Names of Parts Inserting the battery for the Remote Control The CR2032 (3V) lithium battery is used with the remote control. Steering Remote When using the remote control for the first time: Pull out the film in between the cover and the remote contol. • Do not recharge, disassemble, heat or dispose of the battery in fire. • Use a CR2032 (3V) lithium battery only. Never use other types of battery with this unit. • Do not handle the battery with metallic tools.
How to Use Remote Control and Names of Parts Chapter 1 Getting to Know the Components and What They Do Main mode and DIN mode operation Before using this unit, get to know the name of each component and how it is used. (1) The Steering Remote Control (4) (2) (3) Operation mode By switching the Operation mode (Main mode, DIN mode, Navigation mode) you can use one remote control to operate different equipment. Main mode : Operates Pioneer AV Head Unit (e.g.
Microphone Chapter 1 (8) How to Use Remote Control and Names of Parts (8) +/– button The Pioneer Head Unit’s sound volume can be adjusted. (1) Microphone After pressing the VOICE button to start voice operation, this microphone hears your commands. Main unit Navigation mode (navigation operation) ❒ The SRC (SOURCE) button, and 2 / 3 buttons are not used in Navigation mode. 1 3 (1) NAVI/AUDIO button See Main/DIN mode. (Setting C does not need this button.) (2) VOICE button See Main/DIN mode.
How to Use Remote Control and Names of Parts Chapter 1 Setting and removing the disc Insert the disc in the Disc loading slot with the label-side up. To remove the disc, press the Disc eject button on the right-hand side of the Disc loading slot. ❒ Do not try to use discs other than a disc designed for this system. Please use only the disc specified by Pioneer. Setting the PC card Open the cover at the front of the main unit. Hold the PC card label-side up: the arrow shows the direction of insertion.
Appendix Handling and Care of the Disc Ambient conditions for playing disc Some basic precautions are necessary when handling your discs. • At extremely high temperatures, a temperature cutout protects the Navigation System by switching it off automatically. • Despite our careful design of the product, as a result of mechanical wear, ambient conditions for use, or handling of the disc, small scratches that do not affect actual operation may appear on the disc surface.
Specifications Appendix Main unit (GPS receiver) System .................................. L1, C/Acode GPS SPS (Standard Positioning Service) Reception system ................ 8-channel multi-channel reception system Reception frequency ........... 1,575.42 MHz Sensitivity ............................. -130 dbm Position update frequency.. Approx. once per second (Common) Max. output impedance ...... 1 Vp-p, 75 Ω Maximum current consumption ............................................... 2 A Power source .
PIONEER CORPORATION 4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
