Operation Manual

64
Appendix
(4) “Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse.”
When:
The speed signal input (pink lead wire) of the
power cable is not connected.
What to do:
To operate with 3D hybrid mode, connect the
speed signal input (pink lead wire) of the power
cable correctly. Although it can be operated with
Simple hybrid mode without connecting the
speed signal input, the precision of the position-
ing will be less accurate.
(5) “Vibration is detected. Please turn the
system power off and check the instal-
lation. After checking, please re-boot
the system and press “OK” .”
When:
While the car is stationary, the Navigation Sys-
tem is installed in a place where the main unit
may be affected by a large vibration.
What to do:
Re-install the main unit of the Navigation System
in a place where the main unit will not be
affected by vibration.
(6) “Direction of G sensor is not correct.
Please turn the system power off and
check the installation. After checking,
please re-boot the system and press
“OK” .”
When:
Direction of G sensor is set incorrectly.
What to do:
See the “Installation Manual” and set the direc-
tion of G sensor correctly.
(7) “Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center.”
When:
Abnormal output of Gyrosensor is detected.
What to do:
Note down the error code shown on the screen;
turn off the power, and then contact your nearest
Pioneer service facility.
(8) “Your route could not be found.”
When:
If the distance to the destination is too far and
cannot be set.
What to do:
Change the destination to a location that is
closer and divide up the route.
(9) “Your journey can not avoid the speci-
fied area.”
When:
If route setting cannot avoid specified Areas to
Avoid.
What to do:
Choose whether or not to try setting a route
through the area.
(10)“Memory is full.”
When:
If there are already 300 items when you attempt
to register an item in the Address Book.
What to do:
Delete some destinations as appropriate.
(11)“Memory is full.”
When:
When there is no more free space in the PC card.
What to do:
Delete unnecessary data.
(12)“Irregular character strings. Please
input again.”
When:
A symbol that cannot be pronounced was
entered.
What to do:
Enter a word that can be pronounced.
(13)“An error has occurred. Please note
the following error code and switch
power off.”
When:
In the case of a system failure.
What to do:
Note down the error code shown on the screen;
turn off the power, and then contact your nearest
Pioneer service facility.
CRB1881A_06_Eng.fm Page 64 Friday, April 25, 2003 4:32 PM