Owner's Manual

Black plate (30,1)
When installing the antenna inside the vehicle (on the dashboard
or rear shelf)
WARNING
Do not install the GPS antenna over any sen-
sors or vents on the dashboard of the vehicle,
as doing so may interfere with the proper
functioning of such sensors or vents and may
compromise the ability of the metal sheet
under the GPS antenna to properly and se-
curely affix to the dashboard.
2
3
1
4
The metal sheet contains a
strong adhesive which may
leave a mark on the surface
if it is removed.
Note
Make sure the surface is
free of moisture, dust,
grime, oil, etc., before
affixing the metal sheet.
1 GPS antenna
2 Metal sheet
Peel off the protective sheet on the rear.
3 Double-sided tape
4 Clamps
Use clamps to secure the lead where neces-
sary inside the vehicle.
Affix the metal sheet on the surface as level as
possible where the GPS antenna faces the
window. Affix the GPS antenna on the metal
sheet using the double-sided tape.
Notes
! When attaching the metal sheet, do not cut
it into small pieces.
! Some models use window glass that does
not allow signals from GPS satellites to
pass through. On such models, install the
GPS antenna on the outside of the vehicle.
<CRD4951-A>30
En
30
Section
03
Installation